Data bus:	16-bit, ISA
Size:	Half-length, full-height card
Hard drive supported:	Two IDE (AT) Interface drives
Floppy drives supported:	Four 360KB, 720KB, 1.2MB, or 1.44MB drives

CONNECTIONS
Function	Location
34-pin control cable connector - floppy drive	J1
34-pin control cable connector - floppy drive/tape drive	J2
2-pin connector - Drive active LED	J3
40-pin IDE(AT) Interface connector	J4
10-pin serial port (COM1/3) - internal	J5
10-pin serial port (COM2/4) - internal	J6
15-pin game port - external	J7
25-pin parallel port (LPT1/2) - external	J8

USER CONFIGURABLE SETTINGS
Function		Location	Setting
»	Disk change signal is set to normal operation	JP1	closed
	Disk change signal is set to diagnostic mode	JP1	open
»	I/O Channel Ready signal disabled	JP2	closed
	I/O Channel Ready signal enabled	JP2	open
»	Game Port (J7) enabled	JP10	closed
	Game Port (J7) disabled	JP10	open

PARALLEL PORT (J8) CONFIGURATION
LPT/IRQ		JP3	JP6	JP9
»	LPT1/IRQ7	on	off	pins 2 & 3 closed
	LPT2/IRQ5	off	on	pins 1 & 2 closed
	Disabled	off	off	n/a

SERIAL PORT 2 (J6) CONFIGURATION
COM/IRQ		JP4	JP7
»	COM2/IRQ3	closed	pins 1 & 2 closed
	COM4/IRQ5	open	pins 2 & 3 closed

SERIAL PORT 1 (J5) CONFIGURATION
COM/IRQ		JP5	JP8
»	COM1/IRQ4	closed	pins 1 & 2 closed
	COM3/IRQ9	open	pins 2 & 3 closed