Data bus:	16-bit EISA
Size:	Three-quarter length, full-height card
Hard drive supported:	Two IDE(AT) interface drives, up to fourteen SCSI devices
Floppy drives supported:	360KB, 720KB, 1.2MB, 1.44MB

CONNECTIONS
Function	Location
Four-pin connector - SCSI drive active LED	J1
Two-pin connector - IDE(AT) drive active LED	J2
40-pin IDE(AT) interface connector	J3
34-pin control cable connector - floppy drive	J4
50-pin SCSI cable connector - internal	J5
50-pin SCSI cable connector - external	J7

USER CONFIGURABLE SETTINGS
Function		Location	Setting
»	Factory configured - do not alter	J6	N/A
»	IDE interface disabled	J14	closed
	IDE interface enabled	J14	open
»	Floppy drive interface enabled	SW1/1	on
	Floppy drive interface disabled	SW1/1	off
»	Factory configured - do not alter	SW1/2	off

TERMINATION POWER CONFIGURATION
Setting		J10	RN1	RN2	RN3
»	Active termination enabled	closed	not installed	not installed	not installed
	Active termination disabled	open	installed	installed	installed