...because we can't all be on the bleeding edge...





IDE-3296 RMC

BIOTEQ

IDE-3296 RMC

Data Bus

32-bit PCI

Card Size

Half-length, half-height card

Hard Drives supported

Four IDE (AT) drives

Floppy drives supported

None

CONNECTIONS

Function

Location

Function

Location

40-pin primary IDE(AT) connector

CN1

10-pin connector - paddlecard (optional)

JP14

40-pin secondary IDE(AT) connector

CN2

2-pin connector - drive active LED

LED

USER CONFIGURABLE SETTINGS

Function

Label

Position

Disk change enabled

JP13/1

Closed

 

Disk change disabled

JP13/1

Open

IDE base address enabled

JP13/2

Open

 

IDE base address disabled

JP13/2

Closed

IDE(AT) interface enabled

JP13/3

Open

 

IDE(AT) interface disabled

JP13/3

Closed

Native mode enabled

JP15

Closed

 

Native mode disabled

JP15

Open

Secondary INT from drive

JP16

Pins 1 & 2 closed

 

Secondary INT from chip

JP16

Pins 2 & 3 closed

Primary INT from drive

JP17

Pins 1 & 2 closed

 

Primary INT from chip

JP17

Pins 2 & 3 closed

PCI INTERRUPT SELECTION FOR PRIMARY IDE DRIVE

Setting

JP12/1

JP12/2

JP12/3

JP12/4

INTA (non-inverted)

Closed

Open

Open

Open

INTA (inverted)

Open

Open

Open

Closed

INTB (inverted)

Open

Open

Closed

Open

INTC (inverted)

Open

Closed

Open

Open

Note: In normal operation, JP12/4 is closed with primary drive INT14 using INTA. For OPTi54C and Pentium MBD, set JP12/1 closed, selecting non-inverted INTA.

PCI INTERRUPT SELECTION FOR SECONDARY IDE DRIVE

Setting

JP11/1

JP11/2

JP11/3

JP11/4

INTB (non-inverted)

Closed

Open

Open

Open

INTA (inverted)

Open

Open

Open

Closed

INTB (inverted)

Open

Open

Closed

Open

INTC (inverted)

Open

Closed

Open

Open

Note: In normal operation, JP12/4 is closed with primary drive INT14 using INTA. For OPTi54C and Pentium MBD, set JP12/1 closed, selecting non-inverted INTA.

MISCELLANEOUS TECHNICAL NOTE

If your system does not recognize PCI INT, remove jumpers JP11 and JP12 and install paddlecard.