...because we can't all be on the bleeding edge...





WINDJAMMER

DIVERSE LOGISTICS INC.

WINDJAMMER

Maximum Onboard Memory

16MB DRAM (on optional cache controller)

Hard Drives supported

Fourteen SCSI-2 devices

Floppy drives supported

None

Data Bus

External

Card Size

14cm x 23 cm

RAID levels supported

0,1

CONNECTIONS

Function

Location

Function

Location

Proprietary connector - cache controller (optional)

CN1

Proprietary connector - differential converter board (optional)

CN6

Proprietary connector - cache controller (optional)

CN2

68-pin SCSI connector to host - external

CN7

50-pin SCSI connector channel 1 -- internal

CN3

3-pin proprietary JST (RS-232) connector - see note below

CN8

50-pin SCSI connector channel 0 - internal

CN4

Power connector

CN9

50-pin SCSI connector to host - external (optional)

CN5

   

Note: CN8, the JST connector, can be connected to a DE-9 serial connector using a supplied cable that performs signal conversion. This cable allows the Windjammer to be connected to a VT100/VT220 terminal or terminal emulator.

Note: CN6 or CN7 connects the Windjammer controller to the host system. CN6 allows the Windjammer to interface to host systems with differential SCSI ports via an optional differential converter board.

Note: The location of hard drive connectors differs on some boards. If your Windjammer version has a top cover, channel 0 is located on the bottom of the rear panel and channel 1 on the top.

TERMINATION CONFIGURATION

Channel

Controller Position

Termination Required

Controller to Host

At end of SCSI bus

Internal host terminators installed

Controller to Host

Not at end of SCSI bus

Internal host terminators removed

Controller to Host

Active termination required

Internal host terminators removed

Channel 0

At end of SCSI bus

Channel 0 internal terminators installed

Channel 0

Not at end of SCSI bus

Channel 0 internal terminators removed

Channel 0

Active termination required

Channel 0 internal terminators removed

Channel 1

At end of SCSI bus

Channel 1 internal terminators installed

Channel 1

Not at end of SCSI bus

Channel 1 internal terminators removed

Channel 1

Active termination required

Channel 1 internal terminators removed

JST PINOUT

Pin

Description

1

Ground

2

Receive Data

3

Transmit Data