Card Type	Hard drive controller
Hard Drives supported	Four IDE (AT) drives
Floppy drives supported	None
Data Bus	32-bit PCI
Card Size	Half length, full-height

CONNECTIONS
Function	Location	Function	Location
40-pin secondary IDE(AT) connector	CN1	Drive active LED	CN3
40-pin primary IDE(AT) connector	CN2	Paddle board connector	CN4

USER CONFIGURABLE SETTINGS
Function		Label	Position
»	DskChg (removable media) disabled	W2/1	Open
	DskChg (removable media) enabled	W2/1	Closed
»	Base address enabled	W2/2	Closed
	Base address disabled	W2/2	Open
»	PCI chip enabled	W2/3	Open
	PCI chip disabled	W2/3	Closed
»	Factory configured - do not alter	W3/ 1 - 4	Open
»	Factory configured - do not alter	W4/ 1 - 4	Open
»	Factory configured - do not alter	W5	Open
»	Normal base addressing (Legacy mode) enabled	W6/pins 2 & 3	Closed
»	Normal base addressing (Legacy mode) enabled	W7/pins 2 & 3	Closed
Note:W6 & W7 pins 1 & 2 positions are not used.