Data bus:	16-bit ISA
Size:	Three-quarter length, full-height card
Hard drive supported:	Two ESDI drives
Floppy drives supported:	None

CONNECTIONS
Function	Location
20-pin data cable connector	CN1
20-pin data cable connector	CN2
34-pin control cable connector - hard drive	CN3
4-pin connector - drive active LED	J2

USER CONFIGURABLE SETTINGS
Function		Location	Setting
»	Hard disk primary address is 1F0h	J10/1	open
	Hard disk secondary address is 170h (not supported)	J10/1	closed
»	Logical drive splitting enabled	J7/2	closed
	Logical drive splitting disabled	J7/2	open
Note: Other jumper settings not specified.

MISCELLANEOUS TECHNICAL NOTES

A second hard disk cannot be installed when logical drive splitting is enabled. IRQ 14 is used by this controller.