Card Type	Hard drive controller card
Hard Drives supported	Two IDE (AT) drives
Floppy drives supported	Two 360KB, 720KB, 1.2MB, or 1.44MB drives
Data Bus	16-bit ISA
Card Size	Half-length, half-height card

CONNECTIONS
Function	Location	Function	Location
34-pin cable connector - floppy drive	J1	9-pin serial port 1 - external	J5
40-pin primary IDE(AT) connector	J2	25-pin parallel port - external	J6
16-pin game port	J3	2-pin connector - drive active LED	JP1
10-pin serial port 2 - internal	J4

USER CONFIGURABLE SETTINGS
Function		Label	Position
»	Hardware configuration setting	JP3	Pins 2 & 3 closed
	Software configuration setting	JP3	Pins 1 & 2 closed
»	Factory configured - do not alter	JP5	Closed
»	Floppy drive interface enabled	JP6	Closed
	Floppy drive interface disabled	JP6	Open

PARALLEL PORT ADDRESS SELECTION
Setting		JP10	JP11
	LPT1 (378h)	Pins 2 & 3 closed	Pins 1 & 2 closed
»	LPT2 (278h)	Pins 1 & 2 closed	Pins 1 & 2 closed
	LPT3 (3BCh)	Pins 1 & 2 closed	Pins 2 & 3 closed
	Disabled	Pins 2 & 3 closed	Pins 2 & 3 closed

SERIAL PORT 1 & 2 ADDRESS SELECTION
Setting	JP7	JP8	JP9
Serial 1 COM1 / serial 2 COM2	Pins 1 & 2 closed	Pins 1 & 2 closed	Pins 1 & 2 closed
Serial 1 COM1 / serial 2 disabled	Pins 1 & 2 closed	Pins 2 & 3 closed	Pins 1 & 2 closed
Serial 1 COM2 / serial 2 COM1	Pins 1 & 2 closed	Pins 1 & 2 closed	Pins 2 & 3 closed
Serial 1 disabled / serial 2 COM1	Pins 2 & 3 closed	Pins 1 & 2 closed	Pins 2 & 3 closed
Serial 1 disabled / serial 2 COM2	Pins 2 & 3 closed	Pins 1 & 2 closed	Pins 1 & 2 closed
Serial 1 COM2 / serial 2 disabled	Pins 1 & 2 closed	Pins 2 & 3 closed	Pins 2 & 3 closed
Serial 1 disabled / serial 2 disabled	Pins 2 & 3 closed	Pins 2 & 3 closed	N/A

IDE INTERFACE ENABLE
Setting	JP2	JP4
Enable	Closed	Closed
Disabled	Open	Open