CONNECTIONS
Function	Location
34-pin control cable connector-floppy drive	CN1
40-pin IDE (AT) Interface connector-internal	CN5
4-pin connector-drive active LED	CN6
26-pin dual serial port connector-internal	CN8
25-pin parallel port (LPT1/2)-external	CN14
15-pin VGA connector-external	CN401

DUAL SERIAL PORT CONNECTOR (CN8) PIN ASSIGNMENT
Serial Port 1	Serial Port 2	Signal
15	23	Carrier Detect (CD)
5	6	Receive Data (RxD)
3	2	Transmit Data (TxD)
14	10	Data Terminal Ready (DTR)
13	21	Signal Ground
11	4	Data Set Ready (DSR)
7	12	Request To Send (RTS)
9	25	Clear To Send (CTS)
18	8	Ring Indicator (RI)
22	22	Keyed

USER CONFIGURABLE SETTINGS
Function		Location	Setting
»	IRQ14 cleared after read block (SW1/switch 8 must be on)	JP201	1 & 2 closed
	IRQ14 does not clear after read block	JP201	2 & 3 closed
»	Floppy drive controller enabled	SW1/switch 1	on
	Floppy drive controller disabled	SW1/switch 1	off
»	Hard drive port address is 1F0-1F7h	SW1/switch 2	off
	Hard drive port address is 170-177h	SW1/switch 2	on
»	Parallel Port enabled	SW1/switch 3	off
	Parallel Port disabled	SW1/switch 3	on
»	Parallel Port (CN14) is LPT1 (378h)	SW1/switch 4	off
	Parallel Port (CN14) is LPT1 (278h)	SW1/switch 4	on
»	Serial Port 1 set to COM1 (3F8h)	SW1/switch 5	off
	Serial Port disabled	SW1/switch 5	on
»	Serial Port 2 set to COM2 (2F8h)	SW1/switch 6	off
	Serial Port disabled	SW1/switch 6	on
»	Interface Pin 34 Not used	SW1/switch 7	off
	Ground (GND) enabled on Interface pin 34	SW1/switch 7	on
»	Hard drive controller enabled	SW1/switch 8	off
	Hard drive controller disabled	SW1/switch 8	on
»	Factory configured - do not alter	SW401/switch 1	on
»	Factory configured - do not alter	SW401/switch 2	on
»	AT BIOS compatible	SW401/switch 3	on
	PS/2 BIOS compatible	SW401/switch 3	off
»	Standard VGA mode	SW401/switch 4	on
	Multisync VGA mode	SW401/switch 4	off
»	VGA controller enabled	SW401/switch 5	on
	VGA controller disabled	SW401/switch 5	off
»	Standard Interrupt Handling	SW401/switch 6	off
	Special Application Interrupt	SW401/switch 6	on