CONNECTIONS
Function	Location
4-pin connector-drive active LED	J1
9-pin serial port	J2
40-pin control cable connector-hard drive 1	J3
40-pin control cable connector-hard drive 2	J4
34-pin control cable connector-floppy drive	J5

USER CONFIGURABLE SETTINGS
Function		Location	Setting
»	Hard drive port address 1F0-1F7h, 3F0-3F1h, 3F7h	SW1/switch 3	off
	Hard drive port address 170-177h, 370-371h, 377h	SW1/switch 3	on
»	Floppy drive enabled	SW1/switch 4	off
	Floppy drive disabled	SW1/switch 4	on
»	Single-speed floppy supported	SW1/switch 5	off
	Dual-speed floppy supported	SW1/switch 5	on
»	Factory configured - do not alter	SW1/switch 10	off
»	hSOS load enabled	SW1/switch 11	off
	hSOS load disabled	SW1/switch 11	on
»	Factory configured - do not alter	SW1/switch 12	off

BIOS ADDRESS
Address		SW1/switch 1	SW1/switch 2
»	D800h	on	off
	D000h	off	on
	C800h	off	off
	Disabled	on	on

INTERRUPT REQUEST
IRQ		SW1/switch 6	SW1/switch 7	SW1/switch 8	SW1/switch 9
	Disabled	off	off	off	off
	IRQ5	on	off	off	off
	IRQ12	off	on	off	off
»	IRQ14	off	off	on	off
	IRQ15	off	off	off	on

CACHE MEMORY CONFIGURATION
Size	Bank 0	Bank 1
512KB	(2) 256K x 9	NONE
1MB	(2) 256K x 9	(2) 256K x 9
2MB	(2) 1M x 9	NONE
2.5MB	(2) 1M x 9	(2) 256K x 9
4MB	(2) 1M x 9	(2) 1M x 9
8MB*	(2) 4M x 9	NONE
8.5MB*	(2) 4M x 9	(2) 256K x 9
10MB*	(2) 4M x 9	(2) 1M x 9
16MB*	(2) 4M x 9	(2) 4M x 9
Note:* 4MBx9 SIMM's are only supported by the easyCACHE Pro IDE controller

LED INFORMATION
Hard drive read, write, or seek in progress. Lights solid to indicate dirty cache	D1
Data transfer between cache and host in progress.	D2