...because we can't all be on the bleeding edge...





WINSTOR, QUICKCACHE

PERCEPTIVE SOLUTIONS, INC.

WINSTOR, QUICKCACHE

Data bus: 16-bit, ISA

Size: Full-length, full-height card

Hard Drives Supported: Four AT Interface (IDE) drives

Floppy Drives Supported: Two or Four 360KB, 720KB, 1.2MB, or 1.44MB drives

CONNECTIONS

Functiion

Location

4-pin connector-drive active LED

J1

40-pin control cable connector-hard drive 1&2

J3

40-pin control cable connector-hard drive 3&4

J4

34-pin control cable connector-floppy drive

J5

34-pin control cable connector-floppy drive (optional)

J6

50-pin receptacle-Hardware Data Compression Module (winSTOR only)

J7

USER CONFIGURABLE SETTINGS

Function

Location

Setting

Floppy drive enabled

SW1/switch 1

off

 

Floppy drive disabled

SW1/switch 1

on

Single-speed floppy supported

SW1switch 2

off

 

Dual-speed floppy supported

SW1/switch 2

on

Factory configured - do not alter

SW1/switch 3

off

Factory configured - do not alter

SW1/switch 4

off

MISCELLANEOUS TECHNICAL NOTES

Both the winSTOR and the quickCACHE may use 256KB, 1MB or 4MB x8 or x9 SIMM's (100ns or faster). A minimum of 512K cache is required for operation. The winSTOR has 512K on-board and does not require SIMM's to operate.