Data bus:	32-bit, VL-bus
Size:	Three/quarter-length, full-height card
Hard drive supported:	Four IDE (AT) Interface drives
Floppy drives supported:	Four 360KB, 720KB, 1.2MB, 1.44MB, or 2.88MB drives

CONNECTIONS
Function	Location
34-pin control cable connector - floppy drive BUS-0	J1
34-pin control cable connector - floppy drive BUS-1	J2
40-pin IDE (AT) Interface connector IDE-0	J3
40-pin IDE (AT) Interface connector IDE-1	J4
4-pin connector - drive active LED	JP1

USER CONFIGURABLE SETTINGS
Function		Location	Setting
»	Floppy drive enabled	JP2	Closed
	Floppy drive disabled	JP2	Open
»	VL-bus ID3 signal support enabled*	JP4	Closed
	VL-bus ID3 signal support disabled*	JP4	Open
*Note: Open JP4 if your motherboard is 50MHz 486 and does not support ID3 signal.

MISCELLANEOUS TECHNICAL NOTES

At least one pair SIMM of memory modules (256KB, 1MB, or 4MB) of the same size must be installed in Bank 0 in order for the controller to function.