Data bus:	PCI local-bus
Size:	Half-length, half-height card
Hard drive supported:	Four IDE (AT) interface drives
Floppy drives supported:	None

CONNECTIONS
Function	Location
40-pin IDE (AT) Interface connector	CN1
4-pin connector - drive active LED	CN2
40-pin IDE (AT) Interface connector	CN3
10-pin connector - PCI Legacy IRQ Header	JP10

USER CONFIGURABLE SETTINGS
Function		Location	Setting
»	Factory configured - do not alter	J1	N/A
»	IRQ polarity meets PCI specifications	J2	closed
	IRQ polarity does not meet PCI specifications	J2	open
»	On-board IDE channel enabled	J3	open
	On-board IDE channel disabled	J3	closed
»	Factory configured - do not alter	J90	N/A

PCI BUS IRQ SOURCE
IRQ Source		J4	J5
»	Primary IDE IRQ	open	closed
	Secondary IDE IRQ	closed	open

PCI BUS IRQ
Setting		J6	J7	J8	J9
»	IDE IRQ connected to PCI bus IRQA	closed	open	open	open
	IDE IRQ connected to PCI bus IRQB	open	closed	open	open
	IDE IRQ connected to PCI bus IRQC	open	open	closed	open
	IDE IRQ connected to PCI bus IRQD	open	open	open	closed

MISCELLANEOUS TECHNICAL NOTES

JP10 is used to configure the card to comply with the PCI IDE Legacy convention. Pin 4 of JP10 connects to IRQ14 of the Legacy IRQ card to enable IRQ14. Pin 5 of JP10 connects to IRQ15 of the Legacy IRQ Card to enabled IRQ15.