Card Type	Hard drive controller
Maximum On Board Memory	32MB
Hard Drives Supported	Up to 7 SCSI-2 devices
Floppy Drives Supported	Two 360KB, 720KB, 1.2MB, or 1.44MB drives
Data Bus	32-bit EISA
Card Size	Half length, full height

CONNECTIONS
Function	Location	Function	Location
68-pin Ultra SCSI Wide connector - internal	CN1	4-pin connector - drive active LED	J1
50-pin SCSI connector - internal	CN2	68-pin SCSI Wide connector - external	J5
34-pin cable connector - floppy drive	CN3
Note:Do not use both CN1 & CN2 at the same time.

USER CONFIGURABLE SETTINGS
Function	Label	Position
Floppy drive enabled	W8	Closed
Floppy drive disabled	W8	Open

TERMINATION POWER SELECTION
Setting	W1	W2	W3
Enabled	Unidentified	Unidentified	Unidentified
Disabled	Unidentified	Unidentified	Unidentified

DIAGNOSTIC LED
Color	Status	Condition
Unidentified	On	Terminators missing
Unidentified	1 flash	EPROM failure
Unidentified	2 flashes	Local RAM failure
Unidentified	3 flashes	SCSI chip or interface failure
Unidentified	4 flashes	Internal data bus failure
Unidentified	5 flashes	Internal address bus failure
Unidentified	6 flashes	Bus master chip failure
Unidentified	Blinking	Fuse blown