Card Type	Hard drive controller
Hard Drives Supported	Up to 7 SCSI-1 devices
Floppy Drives Supported	Two 360KB, 720KB, 1.2MB, or 1.44MB drives
Data Bus	32-bit EISA
Card Size	Half length, full height

CONNECTIONS
Function	Location	Function	Location
50-pin SCSI connector - external	CN1	34-pin cable connector - floppy drive	CN3
50-pin SCSI connector - internal	CN2	4-pin connector - drive active LED	CN5

USER CONFIGURABLE SETTINGS
Function		Label	Position
»	Floppy drive disabled	JP1	Open
	Floppy drive enabled	JP1	Closed

DIAGNOSTIC LED (CN4)
Color	Status	Condition
Unidentified	On	Terminators missing
Unidentified	1 flash	EPROM failure
Unidentified	2 flashes	Local RAM failure
Unidentified	3 flashes	SCSI chip or interface failure
Unidentified	4 flashes	Internal data bus failure
Unidentified	5 flashes	Internal address bus failure
Unidentified	6 flashes	Bus master chip failure
Unidentified	Blinking	Fuse blown

MISCELLANEOUS TECHNICAL NOTES

Remove terminating resistors only when using internal and external devices at the same time.