...because we can't all be on the bleeding edge...
WD1004A-WX1
WESTERN DIGITAL CORPORATION
WD1004A-WX1
Data bus: 8-bit, PC/AT, PC/AT
Size: Half-length, full-height card
Hard drives supported: Two MFM ST506/412 drives
Floppy drives supported: None
Maximum heads/cyl.: 16 heads and 1024 cylinders
USERS CONFIGURABLE SETTINGS
Function
Location
Setting
»
Hard drive Interrupt request is IRQ5
W27
closed
Hard drive Interrupt request is IRQ2
W27
open
CONNECTIONS
Function
Location
34-pin control cable connector-hard drive
J1
20-pin data cable connector-drive 0
J2
20-pin data cable connector-drive 1
J3
5-pin connector-DC power
J4
4-pin connector-drive active LED
J5
BIOS DRIVE TYPE TABLE - (WD1004-27X ONLY)
Table #
W17
W18
W19
W20
Cap.
Hds.
Cyls.
0
closed
closed
closed
closed
21MB
4
612
1
open
closed
open
closed
10MB
4
306
2
closed
open
closed
open
10MB
2
615
»
3
open
open
open
open
21MB
4
615
I/O PORT & BIOS ADDRESS
I/O Port Address
BIOS Address
W21
W22
»
320-323h
C8000-C9FFFh
open
open
324-327h
CA000-CBFFFh
closed
open
328-32Bh
CC000-CDFFFh
open
closed
32C-32Fh
CE000-CFFFFh
closed
closed
MISCELLANEOUS TECHNICAL NOTES
This controller has a built-in low-level format program. To enter the program run the DEBUG utility supplied with DOS and at the prompt enter: G=C800:5.
If the system is not compatible with the Western Digital BIOS, a resistor must be installed at R23 to disable the WD BIOS