Data bus:	16-bit, ISA
Size:	Half-length, full-height card
Hard drive supported:	Two IDE (AT) Interface drives
Floppy drives supported:	Two 360KB, 720KB, 1.2MB, or 1.44MB drives

CONNECTIONS
Function	Location
40-pin IDE(AT) Interface connector	J1
10-pin serial port (COM2/4) - internal	J2
10-pin serial port (COM1/3) - external	J3
25-pin parallel port (LPT1/2) - external	J4
34-pin control cable connector - floppy drive	J5
2-pin connector - Drive active LED	LED

USER CONFIGURABLE SETTINGS
Function		Location	Setting
	250KB/sec floppy drives supported	J6	open
	300KB/sec floppy drives supported	J6	closed
»	Hard drive Interrupt is IRQ14	J9	pins 1 & 2 closed
	Hard drive Interrupt is disabled	J9	pins 2 & 3 closed
»	I/O Channel Ready signal disabled	JP1	open
	I/O Channel Ready signal enabled	JP1	closed
»	Floppy drive enabled	JP3	closed
	Floppy drive disabled	JP3	open

SERIAL PORT 1 (J3) CONFIGURATION - JP2
J3	Jumper 1	Jumper 2	Jumper 3
IRQ4	closed	open	open
IRQ5	open	closed	open
IRQ9	open	open	closed

SERIAL PORT 2 (J2) CONFIGURATION - JP2
J2	Jumper 4	Jumper 5	Jumper 6
IRQ3	closed	open	open
IRQ9	open	closed	open
IRQ5	open	open	closed

PARALLEL PORT (J4) CONFIGURATION - JP2
J4	Jumper 7	Jumper 8
IRQ5	closed	open
IRQ7	open	closed

SERIAL PORT 1 (J3) CONFIGURATION - JP6
J3	Jumper 1	Jumper 3
3F8h	closed	open
3E8f	open	closed

SERIAL PORT 2 (J2) CONFIGURATION - JP6
J2	Jumper 2	Jumper 4
2F8h	closed	open
2E8h	open	closed

PARALLEL PORT (J4) CONFIGURATION - JP6
J4	Jumper 5	Jumper 6
378h	closed	open
278h	open	closed