Data bus:	16-bit ISA
Size:	Three-quarter length, full-height card
Hard drive supported:	Two ST506/412 drives
Floppy drives supported:	360KB, 720KB, 1.2MB, 1.44MB

CONNECTIONS
Function	Location
34-pin control cable connector - floppy drive	J1
20-pin data cable connector - drive 1	J3
20-pin data cable connector - drive 0	J4
34-pin control cable connector - hard drive	J5
4-pin connector - drive active LED	JP1

USER CONFIGURABLE SETTINGS
Function		Location	Setting
»	Latched hard drive mode enabled	JP2/A	open
	Non-latched hard rive mode enabled	JP2/A	closed
»	Four byte ECC enabled	JP2/B	open
	Reserved	JP2/B	closed
»	Caching enabled	JP2/C	open
	Caching disabled	JP2/C	closed
»	Factory configured - do not alter	JP2/D	N/A
»	Floppy drive interface primary address select	JP3	open
	Floppy drive interface alternate address select	JP3	closed

USER CONFIGURABLE SETTINGS(CONTINUED)
Function		Location	Setting
»	Hard drive interface primary address select	JP4	open
	Hard drive interface alternate address select	JP4	closed
»	Bracket ground disabled	JP5	open
	Bracket ground enabled	JP5	closed
»	Floppy drive interface single speed enabled	JP6	open
	Floppy drive interface dual speed enabled	JP6	closed
Note: The location of jumper JP5 is unspecified in manufacturer documentation.