Data Bus:	VESA local bus
Size:	Mid-length, full-height card
Hard drives supported:	SCSI up to 7 drives
Floppy drives supported:	Two 360KB, 720KB, 1.2MB, or 1.44MB drives

CONNECTIONS
Function	Location
50-pin SCSI External port	CN1
50-pin SCSI internal port	CN2
34-pin data cable connector-floppy drive	CN3
4-pin connector-drive active LED	CN4
Terminating Resistor 1	RN1
Terminating Resistor 2	RN2
Terminating Resistor 3	RN3

USER CONFIGURABLE SETTINGS
Function		Location	Setting
»	Port Address 340h	SW1/1	on
	Port Address 140h	SW1/1	off
»	BIOS enabled	SW1/2	on
	BIOS disabled	SW1/2	off

USER CONFIGURABLE SETTINGS
Function		Location	Setting
»	BIOS support for Floptical/SCSI floppy disabled	SW1/7	off
	BIOS support for Floptical/SCSI floppy enable	SW1/7	on
»	6360 Feature Bit disabled	SW1/8	off
	6360 Feature Bit enabled	SW1/8	on
»	Negotiation enabled	SW1/9	on
	Negotiation disabled	SW1/9	off
»	Disconnect enabled	SW1/10	on
	Disconnect disabled	SW1/10	off
»	Floppy drive enabled	JP5	closed
	Floppy drive disabled	JP5	open
»	Standard SCSI drive type	JP8	open
	Hard drive >1Gb or Floptical	JP8	closed
	Note 1: SW1/7 & SW1/8 have no meaning under BIOS version 1.01L 2:A later version of the BIOS will support the SW1/7 & SW1/8 option. If SW1/7 is set to (On) and the BIOS is later than 1.01L then SW1/8 must be set to (On) for the SW1/7 option to work.

BIOS PORT ADDRESS SETTING
Setting		SW1/3	SW1/4
»	DC000h	on	on
	D8000h	off	on
	CC000h	on	off
	C8000h	off	off

INTERRUPT SELECT
Setting		JP4/A	JP4/B	JP4/C	JP4/D	SW1/5	SW1/6
»	IRQ11	open	open	closed	open	off	on
	IRQ9	closed	open	open	open	off	off
	IRQ10	open	closed	open	open	on	off
	IRQ12	open	open	open	closed	on	on