...because we can't all be on the bleeding edge...





SC499R

ARCHIVE CORPORATION

SC499R

Card Type

Tape drive controller

Chip Set

Unidentified

Maximum Onboard Memory

Unidentified

I/O Options

1/4 inch cartridge tape drive

Tape Format

QIC 11, QIC 24

Data Bus

8-bit ISA

Card Size

Three-quarter length, full-height

CONNECTIONS

Function

Label

Function

Label

Tape drive connector - external

J2

Tape drive connector - internal

J3

USER CONFIGURABLE SETTINGS

Function

Label

Position

Factory configured - do not alter

C

Open

Tape format - QIC-24

CC

Closed

 

Tape format - QIC-11

CC

Open

Factory configured - do not alter

FF

Open

Factory configured - do not alter

HH

Open

Factory configured - do not alter

JJ

Open

Power-on test enabled

KK

Closed

 

Power-on test disabled

KK

Open

Factory configured - do not alter

RR

Open

Track selection - 9

YY

Closed

 

Track selection - 4

YY

Open

DMA CHANNEL SELECTION

Channel

JP6

JP5

JP4

JP3

JP2

JP1

1

Closed

Open

Open

Closed

Open

Open

 

2

Open

Closed

Open

Open

Closed

Open

 

3

Open

Open

Closed

Open

Open

Closed

BASE I/O ADDRESS SELECTION

Setting

CMP3

CMP4

CMP5

CMP6

CMP7

CMP8

CMP9

CMP10

 

0h

On

On

On

On

On

On

On

On

 

8h

Off

On

On

On

On

On

On

On

 

10h

On

Off

On

On

On

On

On

On

 

18h

Off

Off

On

On

On

On

On

On

 

20h

On

On

Off

On

On

On

On

On

200h

On

On

On

On

On

On

Off

On

 

7D8h

Off

Off

On

Off

Off

Off

Off

Off

 

7E0h

On

On

Off

Off

Off

Off

Off

Off

 

7E8h

Off

On

Off

Off

Off

Off

Off

Off

 

7F0h

On

Off

Off

Off

Off

Off

Off

Off

 

7F8h

Off

Off

Off

Off

Off

Off

Off

Off

Note:

A total of 128 base address settings are available. The jumpers are a binary representation of the decimal memory addresses. Jumper CMP10 is the Most Significant Bit and jumper CMP3 is the Least Significant Bit. The jumpers have the following decimal values: CMP10=1024, CMP9=512, CMP8=256, CMP7=128, CMP6=64, CMP5=32, CMP4=16, CMPA3=8. Turn off the jumpers and add the values of the jumpers and convert to hexadecimal to obtain the correct memory address. (Off=1, On=0)

INTERRUPT SELECTION

IRQ

JP7

JP8

JP9

JP10

JP11

JP12

 

IRQ2

Open

Open

Open

Open

Open

Closed

 

IRQ3

Open

Open

Open

Open

Closed

Open

 

IRQ4

Open

Open

Open

Closed

Open

Open

IRQ5

Open

Open

Closed

Open

Open

Open

 

IRQ6

Open

Closed

Open

Open

Open

Open

 

IRQ7

Closed

Open

Open

Open

Open

Open

DIAGNOSTIC LED(S)

Note: The function of the LEDs is unidentified, however on power up or reset all LEDs will light up. When the reset or self test is completed the LEDs will turn off.