Card Type	Data Aquisition
Chip Set	Unidentified
Maximum Onboard Memory	Unidentified
I/O Options	Analog input, digital input
Hard Drives supported	None
Floppy drives supported	None
Data Bus	8-bit ISA
Card Size	Half length

CONNECTIONS
Function	Label	Function	Label
Header connector to expansion board	J1	37-pin analog/digital signals connector	J4
Header connector to expansion board	J2

USER CONFIGURABLE SETTINGS
Function	Label	Position
Port A input enabled	W10	Closed
Port A output enabled	W10	Open
Port B input enabled	W11	Closed
Port B output enabled	W11	Open

BASE I/O ADDRESS SELECTION
Setting		W9	W8	W7	W6	W5	W4	W3
	000h	Open	Open	Open	Open	Open	Open	Open
	008h	Open	Open	Open	Open	Open	Open	Closed
	010h	Open	Open	Open	Open	Open	Closed	Open
	018h	Open	Open	Open	Open	Open	Closed	Closed
	020h	Open	Open	Open	Open	Closed	Open	Open
»	110h	Open	Closed	Open	Open	Open	Closed	Open
	3D8h	Closed	Closed	Closed	Closed	Open	Closed	Closed
	3E0h	Closed	Closed	Closed	Closed	Closed	Open	Open
	3E8h	Closed	Closed	Closed	Closed	Closed	Open	Closed
	3F0h	Closed	Closed	Closed	Closed	Closed	Closed	Open
	3F8h	Closed	Closed	Closed	Closed	Closed	Closed	Closed
Note: A total of 128 base address settings are available. The jumpers are a binary representation of the decimal memory addresses. Jumper W9 is the Most Significant Bit and jumper W3 is the Least Significant Bit. The jumpers have the following decimal values: W9=512, W8=256, W7=128, W6=64, W5=32, W4=16, W3=8. Turn off the switches and add the values of the switches to obtain the correct memory address.(Open=0, Closed=1)

IRQ INTERRUPT SELECTION
IRQ		JP1	JP2	JP3
	IRQ2	Open	Open	Pins 1 & 2 closed
	IRQ3	Open	Pins 1 & 2 closed	Open
	IRQ4	Pins 1 & 2 closed	Open	Open
	IRQ5	Open	Open	Pins 2 & 3 closed
	IRQ6	Open	Pins 2 & 3 closed	Open
	IRQ7	Pins 2 & 3 closed	Open	Open
»	Disabled	Open	Open	Open