Card Type	Data Aquisition
Chip Set	Unidentified
Maximum Onboard Memory	Unidentified
I/O Options	Analog input, digital input
Hard Drives supported	None
Floppy drives supported	None
Data Bus	8-bit ISA
Card Size	Half length

CONNECTIONS
Function	Label	Function	Label
Header connector to expansion board	J1	A/D converter range selector	P2
37-pin analog/digital signals connector	J3	Unipolar offset selector	P3
Bipolar offset selector	P1

USER CONFIGURABLE SETTINGS
Function		Label	Position
»	Factory configured - do not alter	Z10/7	Off

GAIN SELECTION
Function		W1	W2
»	Programmable gain options: x1, x2, x5, x10	Open	Open
	Programmable gain options: x1, x2, x4, x8	Closed	Closed

DMA CHANNEL SELECTION
Channel		JP6/A	JP6/B	JP6/C	JP7/A	JP7/B	JP7/C
»	Disabled	Open	Open	Open	Open	Open	Open
	1	Closed	Open	Open	Closed	Open	Open
	2	Open	Closed	Open	Open	Closed	Open
	3	Open	Open	Closed	Open	Open	Closed

A/D RANGE SELECTION
Polarity		Voltage	JP1	JP2	Z10/8
»	Bipolar	+ 10V	Pins 2 & 3 closed	Pins 2 & 3 closed	On
	Bipolar	+ 5V	Pins 2 & 3 closed	Pins 1 & 2 closed	On
	Unipolar	+0-10V	Pins 1 & 2 closed	Pins 1 & 2 closed	Off

BASE I/O ADDRESS SELECTION
Setting		Z10/1	Z10/2	Z10/3	Z10/4	Z10/5	Z10/6
	000h	Off	Off	Off	Off	Off	Off
	010h	Off	Off	Off	Off	Off	On
	020h	Off	Off	Off	Off	On	Off
	030h	Off	Off	Off	Off	On	On
	040h	Off	Off	Off	On	Off	Off
»	120h	Off	On	Off	Off	On	Off
	3B0h	On	On	On	Off	On	On
	3C0h	On	On	On	On	Off	Off
	3D0h	On	On	On	On	Off	On
	3E0h	On	On	On	On	On	Off
	3F0h	On	On	On	On	On	On
Note: A total of 64 base address settings are available. The switches are a binary representation of the decimal memory addresses. Z10/1 is the Most Significant Bit and switch Z10/6 is the Least Significant Bit. The switches have the following decimal values: Z10/1=512, Z10/2=256, Z10/3=128, Z10/4=64, Z10/5=32, Z10/6=16. Turn off the switches and add the values of the switches to obtain the correct memory address. (On=1, Off=0)