...because we can't all be on the bleeding edge...
INDUSTRIAL COMPUTER SOURCE
16REL-L
|
Card Type |
Parallel card |
|
I/O Options |
serial port |
|
Data Bus |
8-bit ISA |
|
CONNECTIONS |
|
|
Function |
Label |
|
DB-37 connector |
CN1 |
|
USER CONFIGURABLE SETTINGS: PORT ENABLE/DISABLE |
||
|
Setting |
Label |
Position |
|
16REL-L port enabled |
SW1/8 |
On |
|
16REL-L port disabled |
SW1/8 |
Off |
|
BASE I/O ADDRESS SELECTION |
|||||||||
|
Address Port A |
Address Port B |
SW1/1 |
SW1/2 |
SW1/3 |
SW1/4 |
SW1/5 |
SW1/6 |
SW1/7 |
|
|
» |
300 |
303 |
Off |
On |
On |
On |
On |
On |
On |
|
|
304 |
307 |
Off |
On |
On |
On |
On |
On |
Off |
|
|
308 |
30F |
Off |
On |
On |
On |
On |
Off |
On |
|
|
310 |
313 |
Off |
On |
On |
On |
Off |
On |
On |
|
|
314 |
317 |
Off |
On |
On |
On |
Off |
On |
Off |
|
|
320 |
323 |
Off |
On |
On |
On |
Off |
On |
On |
|
|
3A0 |
3A3 |
Off |
Off |
On |
Off |
On |
On |
On |
|
Note: A total of 255 base address settings are available. The switches are a binary representation of the decimal memory addresses. SW1/1 is the Most Significant Bit and switch SW1/8 is the Least Significant Bit. The switches have the following decimal values: SW1/1=256, SW1/2=128, SW1/3=64, SW1/4=32, SW1/5=16, SW1/6=8, SW1/7=4. Turn off the switches and add the values of the switches, including an additional value of 512 as a fixed setting, to obtain the correct memory address. (Off=1, On=0) |
|||||||||
|
MISCELLANEOUS TECHNICAL NOTES |
|
|
» An optional cable is required to bring out the B side of the switches to another 37-pin connector (Port B). » The 16REL-L can be installed into any PC expansion slot, except the J8 slot on the original IBM XT and Portable. |