NIC Type	Ethernet
Transfer Rate	10Mbps
Data Bus	16-bit MCA
Topology	Linear Bus Star
Wiring Type	Unshielded twisted pair DIX transceiver via DB-15 port
Boot ROM	Available

DC CONVERTER ENABLE
Setting		JP1
»	DC signal disabled (10Base-T standard)	Pins 1 & 2 Closed
	DC signal enabled (non 10Base-T network)	Pins 2 & 3 Closed

TRANSMIT LEVEL
Setting		JP2
»	Transmit level select normal (10Base-T standard)	Pins 1 & 2 Closed
	Transmit level select low (non 10Base-T network)	Pins 2 & 3 Closed

TWISTED PAIR IMPEDANCE
Impedance	JP3	JP4	JP5	JP6
75ohm	Pins 1 & 2 closed	Pins 1 & 2 closed	Pins 1 & 2 closed	Pins 1 & 2 closed
100ohm	Pins 2 & 3 closed	Pins 2 & 3 closed	Pins 2 & 3 closed	Pins 2 & 3 closed
150ohm	Pins 3 & 4 closed	Pins 3 & 4 closed	Pins 3 & 4 closed	Pins 3 & 4 closed

LINK TEST ENABLE
Setting	JP7
Link test enabled (10Base-T standard)	Pins 1 & 2 Closed
Link test disabled (non 10Baset-T network)	Pins 2 & 3 Closed
Note:The link test is only valid when the cable type is twisted pair.

RECEIVE LEVEL
Setting		JP8
»	Receive level select normal (10Base-T standard)	Pins 1 & 2 Closed
	Receive level select low (non 10Base-T network)	Pins 2 & 3 Closed

TRANSCEIVER EQUALIZATION
Setting		JP9
»	Transmitter Equalization enabled (10Base-T standard)	Pins 1 & 2 Closed
	Receiver Equalization enabled (non 10Base-T network)	Pins 2 & 3 Closed

MISCELLANEOUS NOTES

The interrupt request and cable type are set using the software that comes with the card.