ADVANCED INTERLINK CORPORATION
AICETHER-8/10BT (BOOT ROM VERSION)
|
NIC Type |
Ethernet |
|
Transfer Rate |
10Mbps |
|
Data Bus |
8-bit ISA |
|
Topology |
Star |
|
Wiring Type |
Unshielded twisted pair |
|
Boot ROM |
Available |
|
INTERRUPT REQUEST | |||||||
|
IRQ |
JP9A |
JP9B |
JP9C |
JP9D |
JP9E |
JP9F | |
|
2 |
Open |
Open |
Open |
Open |
Open |
Closed | |
| » |
3 |
Open |
Open |
Open |
Open |
Closed |
Open |
|
4 |
Closed |
Open |
Open |
Open |
Open |
Open | |
|
5 |
Open |
Open |
Open |
Closed |
Open |
Open | |
|
6 |
Open |
Closed |
Open |
Open |
Open |
Open | |
|
7 |
Open |
Open |
Closed |
Open |
Open |
Open | |
|
I/O BASE ADDRESS | |||
|
Address |
JP9G |
JP9H | |
|
200h |
Closed |
Closed | |
|
210h |
Open |
Closed | |
| » |
300h |
Closed |
Open |
|
310h |
Open |
Open | |
|
BOOT ROM | ||
|
Setting |
JP13 | |
| » |
Disabled |
Open |
|
Enabled |
Closed | |
|
Note:Location of the boot ROM may vary on different revisions of this card. | ||
|
BOOT ROM ADDRESS | ||
|
Address |
JP14A |
JP14B |
|
C800h |
Closed |
Closed |
|
CC00h |
Closed |
Open |
|
D000h |
Open |
Closed |
|
D400h |
Open |
Open |
|
RECEIVE WIRE POLARITY | ||
|
Mode |
SW1 | |
| » |
Normal |
On |
|
Inverted |
Off | |
|
Note:If the diagnostic LEDs indicate that the receive wires' polarities are reversed at the card (LED1 Off, Hub LED
| ||
|
TX/RX CROSSOVER | ||
|
Mode |
SW2 | |
| » |
Normal |
On |
|
Crossover |
Off | |
|
Note:If the diagnostic LEDs indicate that the transmit & receive wires are reversed (LED1 Off, Hub LED Off) you can correct the problem by using the crossover option. | ||
|
DIAGNOSTIC LED(S) | ||
|
LED1 |
Hub LED |
Condition |
|
On |
On |
Network connection is good |
|
Off |
Off |
Transmit/Receive crossover at card |
|
On |
Off |
Receive polarity reversed at hub |
|
Off |
On |
Receive polarity reversed at card |
|
Note:The Hub LED is located on the hub, not on the card. | ||