NIC Type	Ethernet
Transfer Rate	10Mbps
Data Bus	8-bit ISA
Topology	Linear Bus
Wiring Type	RG-58A/U 50ohm coaxial AUI transceiver via DB-15 port
Boot ROM	Not Available

INTERRUPT REQUEST
IRQ		JP1A	JP1B	JP1C	JP1D	JP1E	JP1F
	2/9	Open	Open	Open	Open	Open	Closed
»	3	Closed	Open	Open	Open	Open	Open
	4	Open	Closed	Open	Open	Open	Open
	5	Open	Open	Closed	Open	Open	Open
	6	Open	Open	Open	Closed	Open	Open
	7	Open	Open	Open	Open	Closed	Open

I/O BASE ADDRESS
Address		JP2	JP3
»	220h	Closed	Closed
	280h	Closed	Open
	300h	Open	Closed
	380h	Open	Open

CABLE TYPE
Type		SW1	JP7
»	RG-58A/U 50ohm coaxial	On	Pins 1 & 2 Closed
	AUI transceiver via DB-15 port	Off	Pins 2 & 3 Closed
Note:JP7 is used to enabled the DC converter on the card to supply power to coaxial networks.

SIGNAL QUALITY ERROR (SQE) TEST
Setting		SW2
»	Disabled	Off
	Enabled	On
Note:Signal Quality Error (SQE) is a test of the collision circuitry and path.

DIAGNOSTIC LED(S)
LED	Color	Status	Condition
1	Green	On/Blinking	Data is being transmitted
1	Green	Off	Data is not being transmitted
2	Red	On/Blinking	Collision detected on network
2	Red	Off	Normal operation
3	Yellow	On/Blinking	Data is being received
3	Yellow	Off	Data is not being received
4	Green	On	Card is receiving power
4	Green	Off	Card is not receiving power