...because we can't all be on the bleeding edge...





EN-9000

DANPEX CORPORATION

EN-9000

NIC Type

Ethernet

Transfer Rate

10Mbps

Data Bus

32-bit EISA

Topology

Star

Linear Bus

Wiring Type

RG58A/U 50ohm coaxial

Shielded/Unshielded twisted pair

AUI transceiver via DB-15 port

Boot ROM

Available

ACTIVITY LED ENABLE

Setting

JP1

Disabled

Pins 1 & 2 closed

 

Enabled

Pins 2 & 3 closed

Note:If the network hub has an activity LED for each line, setting this option to enabled will allow the hub LED to operate properly

CABLE TYPE

Type

JP6

Software select

Pins 1 & 2 closed

 

RG58A/U 50ohm coaxial

Pins 2 & 3 closed

ONBOARD TERMINATOR

Setting

JP7

Disabled

Pins 2 & 3 closed

 

Enabled

Pins 1 & 2 closed

Note:When using RG58A/U 50ohm coaxial cable the onboard 50ohm terminator may be used instead of using a T-connector and an external terminator.

DIAGNOSTIC LED(S)

LED

Status

Condition

LED1

On

Data is being transmitted

LED1

Off

Data is not being transmitted

LED2

On

Twisted pair connection is good

LED2

Off

Twisted pair connection is broken

LED3

On

Data is being received

LED3

Off

Data is not being received

LED4

On

Collision detected on network

LED4

Off

No collisions detected on network

FACTORY CONFIGURED SETTINGS

Jumper

Setting

JP2

Unused

JP3

Unused

JP4

Unused

JP5

Unused