NIC Type	Ethernet
Transfer Rate	10Mbps
Data Bus	16-bit ISA
Topology	Linear Bus
Wiring Type	RG58A/U 50ohm coaxial AUI transceiver via DB-15 port
Boot ROM	Available

ACTIVITY LED
Setting	JP1
Enabled	Closed
Disabled	Open
Note:If the network hub has an activity LED for each line, setting this option to enabled will allow the hub LED to

WAIT STATE
Setting		JP5	JP6
»	0 wait states	Open	Open
	1 wait state	Open	Closed
	2 wait states	Closed	Open
Note:This option is ignored if the card is installed in an IBM PC, PC/XT, or PS/2 Model 30.

CABLE TYPE
Type		JP7A - JP7F
»	RG58A/U 50ohm coaxial	Closed
	AUI transceiver via DB-15 port	Open

INTERRUPT REQUEST
IRQ		JP8A	JP8B	JP8C	JP8D	JP8E	JP8F	JP8G
	2/9	Closed	Open	Open	Open	Open	Open	Open
»	3	Open	Closed	Open	Open	Open	Open	Open
	4	Open	Open	Closed	Open	Open	Open	Open
	5	Open	Open	Open	Closed	Open	Open	Open
	10	Open	Open	Open	Open	Closed	Open	Open
	12	Open	Open	Open	Open	Open	Closed	Open
	15	Open	Open	Open	Open	Open	Open	Closed

BOOT ROM
Setting		JP9A
»	Disabled	Open
	Enabled	Closed

BOOT ROM ADDRESS
Address	JP9B	JP9C	JP9D
C8000h	Closed	Open	Closed
CC000h	Open	Open	Closed
D0000h	Closed	Closed	Open
D4000h	Open	Closed	Open

I/O BASE ADDRESS
Address		JP9E	JP9F
»	300h	Closed	Closed
	320h	Open	Closed
	340h	Closed	Open
	360h	Open	Open

ONBOARD TERMINATOR
Setting		JP10
»	Disabled	Pins 1 & 2 closed
	Enabled	Pins 2 & 3 closed
Note:If the card is on either side of the network segment, the onboard terminator may be enabled instead of using a T-connector and an external terminator.