NIC Type	Ethernet
Transfer Rate	10Mbps
Data Bus	16-bit ISA
Topology	Star
Wiring Type	Shielded/Unshielded twisted pair AUI transceiver via DB-15 port
Boot ROM	Available

ACTIVITY LED
Setting	JP1
Enabled	Closed
Disabled	Open
Note:If the network hub has an activity LED for each line, setting this option to enabled will allow the hub LED to

LINK INTEGRITY TEST
Setting		JP2
»	Enabled	Pins 1 & 2 closed
	Disabled	Pins 2 & 3 closed
Note:The link integrity test is valid only when the cable type is shielded/unshielded twisted pair.

CABLE TYPE
Type		JP3
»	Shielded/Unshielded twisted pair	Pins 1 & 2 closed
	AUI transceiver via DB-15 port	Pins 2 & 3 closed

WAIT STATE
Setting		JP4	JP5
»	0 wait states	Open	Open
	1 wait state	Open	Closed
	2 wait states	Closed	Open

INTERRUPT REQUEST
IRQ		JP6A	JP6B	JP6C	JP6D	JP6E	JP6F	JP6G
	2/9	Closed	Open	Open	Open	Open	Open	Open
»	3	Open	Closed	Open	Open	Open	Open	Open
	4	Open	Open	Closed	Open	Open	Open	Open
	5	Open	Open	Open	Closed	Open	Open	Open
	10	Open	Open	Open	Open	Closed	Open	Open
	12	Open	Open	Open	Open	Open	Closed	Open
	15	Open	Open	Open	Open	Open	Open	Closed

BOOT ROM
Setting		JP7A
»	Disabled	Open
	Enabled	Closed

BOOT ROM ADDRESS
Boot ROM Address	JP7B	JP7C	JP7D
C8000h	Closed	Open	Closed
CC000h	Open	Open	Closed
D0000h	Closed	Closed	Open
D4000h	Open	Closed	Open

I/O BASE ADDRESS
I/O Address		JP7E	JP7F
»	300h	Closed	Closed
	320h	Open	Closed
	340h	Closed	Open
	360h	Open	Open

DIAGNOSTIC LED(S)
LED	Status	Condition
LED1	Blinking	Data is being transmitted
LED1	Off	Data is not being transmitted
LED2	On	Twisted pair connection is good
LED2	Off	Twisted pair connection is broken
LED3	Blinking	Data is being received
LED3	Off	Data is not being received
LED4	On	Collision detected on network
LED4	Off	No collisions detected on network
Note:LED2 will only funtion when the cable type is twisted pair, otherwise LED2 will remain off.