Device Type	Redundant Transceiver
NIC Type	Ethernet
Maximum Onboard Memory	Unidentified
Boot ROM	Not available
Network Transfer Rate	10Mbps
Topology	Star
Wiring Type	Unshielded twisted pair
Data Bus	External

CONNECTIONS
Function	Label	Function	Label
AUI transceiver via DB-15	CN1	RJ-45 UTP connector (port 2)	CN3
RJ-45 UTP connector (port 1)	CN2

USER CONFIGURABLE SETTINGS
Function		Label	Position
»	SQE test function disabled	SW1	Off
	SQE test function enabled	SW1	On
	Waits for data for approximately 2sec before switching to redundant port	SW2	MIN
	Waits for data for approximately 10sec before switching to redundant port	SW2	MAX
Note: SW2 should be set to MIN when attached to a high-activity network. The MAX setting should be used with a low-activity network.

PORT 1 PIN CONFIGURATION
Setting	SW3
Crossover enabled	On
Straight-through enabled	Off

PORT 2 PIN CONFIGURATION
Setting	SW4
Crossover enabled	On
Straight-through enabled	Off

DIAGNOSTIC LED(S)
LED	Color	Status	Condition
PWR	Green	On	Power is on
PWR	Green	Off	Power is off
SQE	Yellow	On	Signal Quality Error test function is enabled
SQE	Yellow	Off	Signal Quality Error test function is disabled
XMT	Green	Blinking	Data is being transmitted
XMT	Green	Off	Data is not being transmitted
RCV	Yellow	Blinking	Data is being received
RCV	Yellow	Off	Data is not being received
CLN	Red	Blinking	Collision detected on network
CLN	Red	Off	No collision detected on network
LNK1	Green	On	Port 1 UTP link is good
LNK1	Green	Off	Port 1 UTP link is broken
ACT1	Yellow	On	Port 1 is handling network traffic
ACT1	Yellow	Off	Port 1 is not handling network traffic
ACT1	Yellow	Blinking (slow)	Port 1 is idle. Time out is set to 10 seconds
ACT1	Yellow	Blinking (fast)	Port 1 is idle. Time out is set to 2 seconds
LNK2	Green	On	Port 2 UTP link is good
LNK2	Green	Off	Port 2 UTP link is broken
ACT2	Yellow	On	Port 2 is handling network traffic
ACT2	Yellow	Off	Port 2 is not handling network traffic
ACT2	Yellow	Blinking (slow)	Port 2 is idle. Time out is set to 10 seconds
ACT2	Yellow	Blinking (fast)	Port 2 is idle. Time out is set to 2 seconds