NIC Type	Ethernet
Transfer Rate	10Mbps
Data Bus	32-bit EISA
Topology	Linear bus
Wiring Type	Shielded/Unshielded Twisted Pair AUI transceiver via DB-15 port RG-58A/U 50ohm coaxial
Boot ROM	Available

FACTORY CONFIGURED SETTINGS
Jumper	Setting
JP2	Pins 1 & 2 closed
JP3	Pins 2 & 3 closed

NETWORK VERSION
Version		JP5
»	Ethernet Version 2 (can use all ports)	Pins 1 & 2 closed
	Ethernet Version 1 (uses AUI port only)	Pins 2 & 3 closed

LINK INTEGRITY TEST
Setting		JP6
»	Enabled	Pins 1 & 2 closed
	Disabled	Pins 2 & 3 closed
Note:The link integrity test is only valid when the cable type is unshielded twisted pair.

CABLE TYPE
Type		JP7
	Shielded/Unshielded Twisted Pair	Pins 1 & 2 closed
	AUI transceiver via DB-15 port	Pins 2 & 3 closed
»	RG-58A/U 50ohm coaxial	Pins 3 & 4 closed

SEGMENT LENGTH
Maximum Length		JP8
»	185 meters	Pins 1 & 2 closed
	300 meters	Pins 2 & 3 closed
Note:Segment length is the total length of cable between the two farthest cards on the segment. Each card on the segment must have this option set the same.

ONBOARD TERMINATOR
Setting		JP9
»	Disabled	Pins 1 & 2 closed
	Enabled	Pins 2 & 3 closed
	Notes:If the card is on either end of a linear bus network segment, the onboard terminator may be used instead of using an external terminator.

DIAGNOSTIC LED(S)
LED	Color	Status	Condition
LED1	Green	On	Link is correctly configured
LED1	Green	Blinking	Link is incorrectly configured
LED1	Green	Off	Twisted pair connection not used/Link test is disabled
LED2	Yellow	On	Twisted pair polarity is reversed and corrected
LED2	Yellow	Off	Twisted pair polarity is correct/Twisted pair connection not used
LED3	Green	On	Card is not powered or has failed
LED3	Green	Blinking	Data is being transmitted or received
LED3	Green	Off	Data is not being transmitted or received
LED4	Yellow	On	Collision detected on network
LED4	Yellow	Off	No collisions detected on network