NIC Type	ARCnet
Transfer Rate	2.5Mbps
Data Bus	16-bit ISA
Topology	Linear Bus
Wiring Type	RG-62A/U 93ohm coaxial
Boot ROM	Available

CONFIGURATION MEMORY CLEAR
Clear		JP1
»	Normal operation	Open
	Clear all addresses and settings from memory	Closed

CARDS INSTALLED
Card number	JP2A	JP2B	JP2C	JP2D
1	Closed	Open	Open	Open
2	Open	Closed	Open	Open
3	Open	Open	Closed	Open
4	Open	Open	Open	Closed
Note:If there is only one NIC installed in a system, set this option to the "1" position. If this NIC is the second NIC to be installed in a system, set this option to the "2" position and so on.

COMPATIBILITY MODE
Condition		JP3
»	Compatibility mode disabled	Open
	Compatibility mode enabled	Closed
Note: Compatibility mode should be enabled when the NIC is installed in a system using a Suntac 286 chipset.

DIAGNOSTIC LED(S)
LED	Color	Status	Condition
LED1	Red	Blinking	I/O bus activity
LED1	Red	Off	No I/O bus activity
LED2	Green	On	Data is being transmitted or received
LED2	Green	Blinking	No network activity detected, or bad connection