...because we can't all be on the bleeding edge...





PDI8023-16FL

PURE DATA, LTD.

PDI8023-16FL

NIC Type

Ethernet

Transfer Rate

10Mbps

Data Bus

16-bit ISA

Topology

Star

Wiring Type

62.5/125 m m Fiber optic cable (e.g. Belden 227412)

Boot ROM

Available

SOFTWARE CONFIGURATION RESET

Setting

E1

Normal operation

Pins 2 & 3 closed

 

Reset

Pins 1 & 2 closed

Note:Many of the options are configured using the setup utility provided with the card. To reset those configurations to the factory defaults, move E1 to the Reset position (pins 1 & 2 closed) and apply power for a few seconds. Always make sure that you turn off the power to the computer before you change any jumpers.


CARD I/D NUMBER

Number

E2A

E2B

E2C

E2D

1

Open

Open

Open

Closed

 

2

Open

Open

Closed

Open

 

3

Open

Closed

Open

Open

 

4

Closed

Open

Open

Open

Note:Up to four cards can be installed into a system at the same time. If more than one card is installed each one must have a seperate card I/D number.

EXTENDED TRANSMIT TIMEOUT AND SIGNAL QUALITY ERROR (SQE) TEST

Timeout

SQE

E6A

E6B

E6C

Enabled

Enabled

Closed

Open

Open

Disabled

Disabled

Open

Closed

Open

Enabled

Disabled

Open

Open

Closed

Note:With extended transmit timeout enabled, if the card is transmitting for an extented amount of time the transmission will be interrupted and continued after a preset time. This keeps the card from dominating the network.

Signal Quality Error (SQE) is a test of the collision circuitry and path.

E6 is located on the PIM.

LOOP BACK ENABLE

Setting

E7

Disabled

Pins 1 & 2 closed

 

Enabled

Pins 2 & 3 closed

Note:A loop back connector is used with diagnostic software to trouble-shoot the card.

E7 is located on the PIM.

FACTORY CONFIGURED SETTINGS

Jumper

Setting

E5A

Closed

E5B

Open

E5C

Open

DIAGNOSTIC LED(S)

LED

Color

Status

Condition

LED1

Green

On

Data is being transmitted

LED1

Green

Off

Data is not being transmitted

LED2

Amber

On

Data is being received

LED2

Amber

Off

Data is not being received

LED3

Amber

On

Network connection is good

LED3

Amber

Off

Network connection is broken

LED4

Red

On

Card is transmitting for an extended time

LED4

Red

Off

Normal operation

LED5

Red

On

Collision detected on network

LED5

Red

Off

Normal operation