ZENITH DATA SYSTEMS
XT LANCARD
|
NIC Type |
Ethernet |
|
Transfer Rate |
10Mbps |
|
Data Bus |
8-bit ISA |
|
Topology |
Linear Bus |
|
Wiring Type |
Broadband Modem via DB-15 port |
|
Boot ROM |
Available |
|
BOOT ROM | ||
|
Setting |
JP1 | |
| » |
Disabled |
Open |
|
Enabled |
Closed | |
|
Note:The location of the Boot ROM socket may vary on different revisions of this card. | ||
|
BASE MEMORY ADDRESS, I/O BASE ADDRESS, AND BOOT ROM ADDRESS | ||||
|
Base Memory Address |
I/O Address |
Boot ROM Address |
JP2 | |
| » |
D0000h |
0360h |
CC000h |
Closed |
|
D8000h |
0368h |
CE000h |
Open | |
|
CONFIGURATION MEMORY | ||
|
Setting |
JP4 | |
| » |
Configuration memory normal operation |
Open |
|
Configuration memory reset to factory defaults |
Closed for 30 seconds during power-up | |
|
INTERRUPT REQUEST | ||
|
IRQ |
JP5 | |
| » |
2 |
Pins 1 & 2 Closed |
|
3 |
Pins 2 & 3 Closed | |
|
DIAGNOSTIC LED(S) | ||
|
LED |
Status |
Condition |
|
LED1 |
On |
Modem is bad or not connected |
|
LED1 |
Blinking |
Network activity detected |
|
LED2 and LED3 |
On |
Self test completed normally |
|
LED2 and/or LED3 |
Off |
Self test failed, will display error code on screen. |
|
FACTORY CONFIGURED SETTINGS | |
|
Jumper |
Setting |
|
JP3 |
Factory test only |