Device Type	Internal Tape Drive
Interface	SCSI-1, SCSI-2
Format	QIC-120, QIC-150, or QIC525 (write) QIC-24, QIC-120, QIC-150, or QIC-525 (read)
Sustained Transfer Rate	200 KBPS
Size	5.25 in. half height
View	Bottom

CONNECTIONS
Function	Label
Chassis ground connector	W1

USER CONFIGURABLE SETTINGS
Setting		Label	Position
»	Factory configured - do not alter (Built in test mode(s))	E2	Open
»	Factory configured - do not alter	E3	Unidentified
»	Factory configured - do not alter (Built in test mode(s))	E4	Open
»	Factory configured - do not alter (48 MHz main oscillator enabled)	E5	Closed
»	1024 byte block mode enabled	JP2	Open
	512 byte block mode enabled	JP2	Closed
»	Factory configured - do not alter (Built in test mode(s))	JP3	Open
»	Factory configured - do not alter (Built in test mode(s))	JP6	Open
»	Factory configured - do not alter	JP7	Unidentified
»	Factory configured - do not alter	JP8	Unidentified
»	Factory configured - do not alter	JP9	All pins open
»	Factory configured - do not alter (Built in test mode(s))	JP12	Open
»	Factory configured - do not alter (Diagnostic test connector)	JP32	Open

DRIVE SELECT ID
Drive ID		JP1/A	JP1/B	JP1/C
»	0	Open	Open	Open
	1	Closed	Open	Open
	2	Open	Closed	Open
	3	Closed	Closed	Open
	4	Open	Open	Closed
	5	Closed	Open	Closed
	6	Open	Closed	Closed
	7	Closed	Closed	Closed
Note: Jumper JP1/D is factory configured and should not be altered. The default position for JP1/D is Open.

TERMINATION POWER SELECTION
Setting		E1
»	TERMPWR supplied by drive	Closed
	TERMPWR supplied by SCSI interface to drive	Open
Note: The fuse at F1 must be installed when TERMPWR is supplied by the drive.

MISCELLANEOUS TECHNICAL NOTES

Termination is enabled or disabled via the three removable terminating resistors (see diagram).