...because we can't all be on the bleeding edge...





SIDEWINDER 200 EXTERNAL

SEAGATE TECHNOLOGY, INC.

SIDEWINDER 200 EXTERNAL

Device Type

External Tape Drive

Interface

SCSI-2 Fast/Wide

Format

AIT-1

Sustained Transfer Rate

3MBPS (Native), 6 to 9GB (Compressed)

Size

5.25 in. half height

View

Bottom

DRIVE SELECT ID

Note:To select the SCSI ID, press SW1 until the ID you desire is shown in the switch viewer. The address is shown in hexadecimal.

USER CONFIGURABLE SETTINGS

Setting

Label

Position

Parity check enabled

JP1/1

Open

 

Parity check disabled

JP1/1

Closed

Factory configured - do not alter

JP1/2

Unidentified

Factory configured - do not alter

SW2/1

Unidentified

Factory configured - do not alter

SW2/2

Unidentified

Factory configured - do not alter

SW2/3

Unidentified

Factory configured - do not alter

SW2/4

Unidentified

Data compression enabled

SW2/7

On

 

Data compression disabled

SW2/7

Off

Factory configured - do not alter

SW2/8

On

MANUFACTURERS RECOMMENDED MEDIA

Tape

Capacity Without Compression

Capacity With Compression

AIT-1

100GB

200+ GB

DIAGNOSTIC LED(S)

LED

Color

Status

Condition

LED1

Unidentified

On

Unit power is on

LED1

Unidentified

Off

Unit power is off

LED2

Green

On

SCSI interface is ready for data transfer

LED2

Green

Off

Drive is not in use

LED2

Green

Blinking

Drive is either searching for data, reading/writing to tape, or rewinding the tape

LED3

Green

On

Cartridge is loaded into drive

LED3

Green

Blinking

Cartridge is unloaded from drive