...because we can't all be on the bleeding edge...





DONATELLO (INTERNAL), DONATELLO MAC (INTERNAL)

DIGICOM SPA

DONATELLO (INTERNAL), DONATELLO MAC (INTERNAL)

Card Type

ISDN, Modem

Chip Set

Unidentified

I/O Options

ISDN interface via RJ-45 connector, headphone, microphone, speaker, 25-pin serial port, power

ISDN Rate

64Kbps x 2

Maximum Modem Rate

33.6Kbps

Maximum Fax Rate

ISDN Modulation Protocol

14.4Kbps

V.110, V.120

Data Modulation Protocol

Bell 103J/212A,

ITU-T V.21, V.22, V.22bis,V.23, V.32, V.32bis, V.34, K56flex

Fax Modulation Protocol

V.17, V.29, V.27

Error Correction/Compression

MNP5, V.42, V.42bis

Fax Class

Class I

Data Bus

16-bit ISA

CONNECTIONS

Function

Label

Function

Label

ISDN interface (RJ-45 connector)

CN1

Reset

P1

USER CONFIGURABLE SETTINGS

Setting

Label

Position

í Transmission channel in high impedence mode

U4

Pins 2 & 3 closed

Transmit termination set to 100Ohm

U4

Pins 1 & 2 closed

í Receive channel in high impedence mode

U5

Pins 2 & 3 closed

Receive termination set to 100Ohm

U5

Pins 1 & 2 closed

í Interrupt 14 enabled

U8

Pins 2 & 3 closed

Interrupt 14 disabled

U8

Pins 1 & 2 closed

ADDRESS SELECTION

Setting

DS1/1

DS1/2

COM1 (3F8h)

Off

Off

COM2 (2F8h)

Off

On

COM3 (3E8h)

On

Off

COM4 (2E8h)

On

On

INTERRUPT SELECTION

IRQ

DS1/3

DS1/4

DS1/5

DS1/6

DS1/7

DS1/8

IRQ3

On

Off

Off

Off

Off

Off

IRQ4

Off

On

Off

Off

Off

Off

IRQ5

Off

Off

On

Off

Off

Off

IRQ10

Off

Off

Off

Off

On

Off

IRQ11

Off

Off

Off

Off

Off

On

SUPPORTED COMMAND SET (DIGITAL)

Basic AT Commands

AT, A/

A, E, Q, V, W

&C, &Z

S Registers

S2, S3, S4, S12, S25, S26

 

Note: See MHI Help File for full command documentation.

SUPPORTED COMMAND SET (ANALOG)

Basic AT Commands

AT, A/

A, B, E, H, L, M, O, Q, V, W, X, Y, Z

&C, &G, &T, &V, &W, &Y, &Z

Extended AT commands

\A, \B, \K, \N

%C, %E, %L, %Q

#CID

S Registers

S0, S1, S2, S3, S4, S5, S6 ,S7, S8, S9, S10, S11, S12, S18, S29, S30, S32, S33

Special commands

+MS, -K, )M

Voice AT commands

#VBT, #VRX, #VSP, #VSR, #VSS, #VTS, #VTX

 

Note: See MHI Help File for full command documentation.

For a full command summary, see DIGICOM SPA DONATELLO (EXTERNAL), DONATELLO MAC (EXTERNAL)