CONNECTIONS
Purpose	Location	Purpose	Location
Line out	CN1	Power in	CN4
Line in	CN2	Volume	R1
RS-232/422	CN3	Power switch	SW2

DIAGNOSTIC LED(S)
LED	Color	Status	Condition
LED1	Red	On	Analog loopback self test mode
LED1	Green	On	Data mode
LED2	Red	Blinking	Modem is transmitting/receiving data
LED2	Green	On	Carrier signal detected

DTR SIGNAL
Setting	SW1/1
» On	DTR forced high
Off	DTR normal

RESULT CODES
Setting	SW1/2
» Off	Extended result codes enabled
On	Extended result codes disabled

RESULT CODES DISPLAY
Setting	SW1/3
» On	Display disabled
Off	Display enabled

ECHO DISPLAY
Setting	SW1/4
» Off	Local echo enabled
On	Local echo disabled

AUTO ANSWER
Setting	SW1/5
» On	Modem doe not answer on first ring
Off	Modem answers on first ring

CARRIER DETECT
Setting	SW1/6
» Off	CD normal
On	CD forced high

MULTIPLE PHONE INSTALLATION
Setting	SW1/7
» Off	Single phone connected
On	Multiple phones connected

AT COMMAND SET
Setting	SW1/8
» On	AT command set recognized
Off	AT command set disabled

TIME DISPLAY
Type:	Immediate
Format:	AT [cmds] Kn [cmds]
Example:	AT K1 *L2 #E1<CR>
Description:	Displays the current call time or clock time.
Command	Function
K0	Display length of last call.
K1	Display actual time.

HELP SCREENS
Type:	Immediate
Format:	AT <prefix>$
Example:	AT &$<CR>
Description:	Shows command help screens for all commands beginning with the given prefix, or no prefix if none is given.
Command	Function
$	Shows ATx help screen.
D$	Shows ATDx help screen.
S$	Shows S-register help screen.

REPEAT COMMAND STRING
Type:	Configuration
Format:	AT [cmds] >
Example:	AT DT1(303) 443-3388 > <CR>
Description:	Causes modem to repeat command string until a keyboard key is pressed.

ANALOG LOOPBACK SELF TEST
Type:	Register
Format:	AT [cmds] S16=n [cmds]
Example:	ATS16=139<CR>
Description:	Selects the tone dialing test.
Command	Function
0	Data mode.
1	Analog loopback.
2	Dial testing.
4	Test pattern.
5	Analog loopback and test pattern.