TUCoPS :: Radio :: ic10_5.txt

Kenwood TS-440 Computer Interfacing

IC10.5

                Memory Write           
                ____________
MWnxrrggmmmkkkhhhdzxxxx;
                The Memory Selected Will be Set to the Frequency Defined
                        Where:  n = 0 for RX VFO
                                    1 for TX VFO (Split Channels Only)
                                x = Don't Care  (Use "0" or Space)
                               rr = Memory Channel No.    (00 thru 99)
                          gg~~hhh = Value as defined in FA Command
                                d = Value as defined in MD Command
                                z = "0" (Not Used in TS-440)


                RIT/XIT Clear
                _____________
RC;
                The RIT/XIT will be set to 0.00 kHz.


                RIT/XIT Down
                ____________
RD;
                The RIT/XIT will Decrement by 0.01 KHz. (10 Hz.)


                RIT/XIT UP
                __________
RU;
                The RIT/XIT will Increment by 0.01 KHz. (10 Hz.)


                RIT (ON/OFF)
                ____________
RTn;
                The RIT Status Will be Selected
                        Where   n = 0 for RIT OFF
                                    1 for RIT ON


                Receive
                _______
RX;
                Radio Will Enter Receive Mode     (PTT Released)


                Scan (ON/OFF)
                _____________
SCn;
                The Scan Status Will be Selected
                        Where   n = 0 for Scan OFF
                                    1 for Scan ON
CONTINUED IN IC10.6
 

TUCoPS is optimized to look best in Firefox® on a widescreen monitor (1440x900 or better).
Site design & layout copyright © 1986-2024 AOH