PANASONIC HH 700/900

NOTES:  This is a dual NAM hand held unit.
        The ESN prefix is 136 decimal & 88 hex.
        Panasonic: 1-800-922-0028


NAM PROGRAMING:

1.  Turn power on.

2.  Within 20 seconds enter * 0 # 0 * 0 # 0 * 1 FCN ALPHA for NAM 1
    or * 0 # 0 * 0 # 0 * 2 FCN ALPHA for NAM 2.

3.  Each data entry can be looked at by pressing RCL followed by the
    location (step) number below.

4.  To store new data enter the value, press STO followed by the location
    (step) number below.  For example to enter a system ID of 00031 enter
    00031 STO 01.  Data can be entered or reviewed in any order.

5.  At any time press STO * * to complete programing.

6.  Press END to exit.


PROGRAMING DATA:

STEP#    #OF DIGITS/RANGE    DISPLAY        DESCRIPTION

01       00000 - 32767       SIDH           SYSTEM ID
02       10 DIGITS           OWN DIAL       MIN (AREA CODE & TEL NUMBER)
03       0 OR 1              PRESYS         PREFERRED SYSTEM
04       333 OR 334          IPCH           INITIAL PAGING CHANNEL
05       2 DIGITS            ACCOLC         ACCESS OVERLOAD CLASS
06       2 DIGITS            GIM            GROUP ID (10 IN USA)
07       2 TO 4 DIGITS       LOCK CODE      LOCK CODE
08       8 DIGIT, 0 OR 1     FCN 1          SEE NOTE 1 BELOW.
09       8 DIGIT, 0 OR 1     FCN 2          SEE NOTE 2 BELOW
10       NOT USED                           NOT USED
11       UP TO 12 DIGITS     EMERGENCY      EMERGENCY NUMBER

NOTES:

1.  Suggested entry is: 11100000.

Bit 7/Digit 1 = Local use Mark
Bit 6/Digit 2 = MIN Mark
Bit 5/Digit 3 = Allow user A/B system select
Bit 4/Digit 4 = Not Used
Bit 3/Digit 5 = Not Used
Bit 2/Digit 6 = Not Used
Bit 1/Digit 7 = Not Used
Bit 0/Digit 8 = Not Used

2.  Suggested entry is: factory default.

Bit 7/Digit 1 = Built in Monitor
Bit 6/Digit 2 = Battery save mode
Bit 5/Digit 3 = DTMF
Bit 4/Digit 4 = Not Used
Bit 3/Digit 5 = Not Used
Bit 2/Digit 6 = Not Used
Bit 1/Digit 7 = Not Used
Bit 0/Digit 8 = Not Used



LOCK: F 3 1 lock code, +/- toggles mode.

UNLOCK: Enter two to four digit code.

A/B SYSTEM SELECT: F 7 2, then +/- to select, STO to store.