TUCoPS :: Phreaking Cellular - Other Manufacturers :: radios~6.txt

Radio Shack CT-201 NAM Programming


CT-201 (170-1005) NAM Programming Instructions

STEP 1 (Enter Program Mode):

Type:   *17*1003*LOCK*
[Archiver's Note: If this doesn't work, try *17*1005*LOCK* --drwho ]
(The factory LOCK code is 1234)

STEP 2 (Programming the Primary NAM information):

The phone will now inform you of the parameter it wants you to enter on the
top line with the previously programmed parameter (or factory default) on
second line. The starred (*) lines require information that MUST be
supplied by the cellular carrier.

*Line 1 of Phone: HO-Id      Type:  5-digit Home System ID then
 Line 1 of Phone: ACCESS     Type:  1 then
 Line 1 of Phone: LOCAL      Type:  1 then
*Line 1 of Phone: Phone n    Type:  10-digit phone number then
 Line 1 of Phone: CLASS      Type:  0 8 then
*Line 1 of Phone: PAGE ch    Type:  3-digit Paging Channel then
                                            (Note: Channel A is: 333,
                                                   Channel B is: 334)

 Line 1 of Phone: O-Load     Type:  0 and last digit of phone # then
*Line 1 of Phone: Group      Type:  2-digit Group ID then
 Line 1 of Phone: SEC        Type:  4-digit LOCK Code then

 The phone will return to the normal power-on mode. The phone should now
 be correctly programmed. It is important to remember that it will take a
 cellular carrier several hours to activate a cellular phone number.

Settings List:

 1     Display Carrier Priority
 11    Change Carrier Priority (A/B)
 2     Enable/Disable Horn Alert
 3     Display Time of Last Call
 33    Display Call Timer Total
 44    Enable/Disable Key Entry Tone
 5     Auto Shutoff
 +     High Power
 -     Low Power
*LOCK*      Reset Timer

TUCoPS is optimized to look best in Firefox® on a widescreen monitor (1440x900 or better).
Site design & layout copyright © 1986-2024 AOH