ft2700rh.2

Testing:

   You should see the 2700 scanning between channels #1 and #2 at a rate of

   about 3 cps. Open the squelch and you should see the tx coming on the

   air. Close the squelch and scanning should resume. Note that the rx

   volume control has no effect on audio level going out on the air.

   Now the pot VR1 will need to be adjusted. There are 3 ways of doing that:

   1. Use reports from other stations



   2. Better than that, use the old VU METER trick.



   3. Best, use a deviation monitor.

continued in ft2700rh.3