IC02AT.10
  7.  Carefully apply power to radio and enter the lowest desired frequency.

  8.  Adjust slug through bottom hole on VCO cover for .5 VDC at VCO test
      point (just below VCO shield) at lowest desired operating frequency.

  9.  This completes the modification.  A few words of caution:  1.  The
      radio is not type accepted for use in the commercial band.  2.  Make
      sure you reinstall the battery latch correctly on bottom of radio or
      battery will become permanently locked onto radio.  3.  Tighten screws
      on bottom of radio snuggly.  If they loosen while battery is connected
      you cannot remove the battery.  (This has happened to many units and
      it would be prudent to periodically check these screws to assure their
      tightness.)

                     ------------------------------------

 ***->Be careful not to transmit out-of-band, or accidentally operate on
      any non-amateur, unless you are authorized to do so.

                       DO NOT JEOPARDIZE YOUR LICENSE!

                    RELAYED  BY...N0KGX...GENE