TUCoPS :: Radio :: ic04at_4.txt

Modification 1 for Icom 04at Handheld

IC04AT.4

Subject: ICOM 02/03/04 & Vox Unit

The ICOM Family of Hand-Held Radios (02/03/04 AT) are well suited
for packet radio given the many available power supply options.

The big problem is getting the PTT to operate " CLEANLY " while
not compromising the audio level from the TNC when using the resistor
or resistor/capacitor interfaces suggested in some manuals.

I am using the ICOM HS10-SA Vox unit to interface the ICOM 02/04 AT
here.It has worked somewhat well for some time but I was always plagued with
a MINIMUM 200 msec transmit "hang " delay until I tore it apart for
examination and correction.

The small " delay " pot on the front of the unit is in series with a
2.2 Megohm resistor (R-19 on the board). The adjustable pot is also
about 2 megohms as well. This combination allows a MINIMUM VOX "hang" transmit
delay of 200 msec.

By identifiying the solder connections for R-19 on the back of the PC board
and placing a low value resistor ( or jumper )  in parallel....I was able to
achieve a ZERO "hang" transmit delay time with the delay pot in the FULL
COUNTER-CLOCKWISE position. The minimum 200 msec delay has been defeated.

73 Harold - N4KWB @ W4NVU 

TUCoPS is optimized to look best in Firefox® on a widescreen monitor (1440x900 or better).
Site design & layout copyright © 1986-2024 AOH