===---->>>>> Compiled by Soft Beard 1990 <<<<<----===
Accessing Telecom Australia`s AUSTPAC service.
AUSTPAC is a great way to connect to major companies. This is how it works:
You call AUSTPAC for 20cents, then you can make up to 5 connect tries
before it cuts you off. When you dial a number in the format ?xxxxxxxxx
you will be connected at the service providers cost, ie. if it is a company
in the US, the company will pay the bill!! This is great as most companies
allow you to attempt to log on 3 times, but with AUSTPAC you can go through
15 password attempts per call. Some of the systems even have limitless
attempts, they pay for the american call and you sit there all night going
through password libraries!!!
Phone Numbers:
01921 - v21, 300baud
01922 - v22, 1200baud
01923 - v23, 1200/75baud
01924 - v22bis, 2400baud
(not sure about 9600, 19200 baud but who can afford them!!??)
The only problem with the service is that it acts as a centre point and while
you connect to it at 2400baud it actually connects to the service at 9600
or 19200 baud depending on the service. This unfortunately can cut you off
if you are receiving text so it is best to press [SPACE] or something similar
every few minutes so you don`t get an inactivity log off. When receiving
files this is a pain and you USUALLY get cut off so make sure if downloading
you are Batch-Downloading.
There are thousands and thousands of services on AUSTPAC. Pick up a list from
your local HackBBS or write your own simple comms program to go through a
big list, 5 per call, 4c a try, so this works out to around $4.00 to check
almost 100 NUA`s.
An NUA is the name of the number to a service provider specified with
?xxxxxxxxx. It is sometimes the case where you also need to provide an NUI
after the initial NUA in the same format ?xxxxxxxxx to connect.
A complete list of error codes is listed below:
ERROR MESSAGES DESCRIPTION OF THE ERROR MESSAGES
======== ============================================================
CLR CONF CLEAR CONFIRMATION - THE LOCAL PAD HAS CLEARED THE CALL.
CLR DER OUT OF ORDER - THE X.25 LINK BETWEEN THE NETWORK AND
THE REMOTE PAD IS DOWN.
(FRAME AND/OR PACKET LEVEL)
CLR DTE HOST DISCONNECT - A CALL CLEAR HAS BEEN INITIATED BY THE
REMOTE PAD.
CLR ERR PROCEDURE ERROR - THE NETWORK HAS DETECTED A PROCEDURE
ERROR ON THE LOCAL X.25 LINK CAUSED BY
THE LOCAL PAD.
CLR INV INVALID FACILITY - THE LOCAL PAD HAS REQUESTED A FACILITY
THAT IS NOT VALID OR IS NOT PROVISIONED
ON THE NETWORK.
CLR NA ACCESS BARRED - A CALL REQUEST INTO A CLOSED USER GROUP
HAS BEEN CLEARED BECAUSE THE USER HAS
NOT BEEN VALIDATED BY THE USER GROUP.
CLR NC NETWORK CONGESTION - THE CALL REQUEST TEMPORARILY CANNOT BE
ROUTED THROUGH THE NETWORK. (PROBABLE
CAUSE - A NETWORK NODE IS DOWN.)
CLR NP NOT OBTAINABLE - THE DESTINATION OF THE CALL REQUEST IS
OUT OF THE NUMBERING PLAN OR IS NOT
ASSIGNED IN THE NETWORK.
CLR OCC NUMBER BUSY. - THE NETWORK HAS DETERMINED THAT ALL
AVAILABLE LCN'S TO THE REMOTE PAD ARE
IN USE. THE CALL REQUEST CANNOT BE
COMPLETED AT THIS TIME.
CLR PAD PAD CLEARING - THE CALL HAS BEEN CLEARED BY THE LOCAL
PAD BECAUSE AN INVITATION TO CLEAR WAS
RECEIVED FROM THE REMOTE PAD.
CLE RPE PROCEDURE ERROR - THE NETWORK HAS DETECTED A PROCEDURE
ERROR ON THE REMOTE X.25 LINK CAUSED
BY THE REMOTE PAD.
NOTE: ALL CAUSE CODES NOT LISTED ABOVE WILL BE DISPLAYED
----- IN A THREE DECIMAL NUMBER FORMAT.
THE DIAGNOSTIC CODE, IF PRESENT, WILL BE DISPLAYED
AFTER THE THREE CHARACTER/NUMBER CAUSE CODE.
EG: CLR DTE XXX OR CLR XXX XXX
CLR ERR 200 THE LOCAL PAD RECEIVED A RESTART REQUEST.
CLR ERR 201 A LOCAL PROCEDURE ERROR CAUSES THE NETWORK TO SEND A
RESTART REQUEST TO THE LOCAL PAD.
CLR ERR 203 NETWORK CONGESTION CAUSED THE NETWORK TO SEND A RESTART
REQUEST TO THE LOCAL PAD.
CLR ERR 207 NETWORK RESTART.
CLR ERR 231 THE LOCAL PAD RECEIVED A FRAME-LEVEL "COMMAND REJECT/
FRAME REJECT" WITH THE Y-BIT SET TO 1 BECAUSE THE PAD
SENT AN "I" FRAME EXCEEDING THE MAXIMUM LENGTH ALLOWED.
THE CLEAR REQUEST IS SENT AT THE PACKET-LEVEL.
CLR ERR 232 THE LOCAL PAD CLEARED THE CALL BECAUSE IT RECEIVED AN
INVITATION TO CLEAR FROM THE NETWORK.
CLR ERR 237 CALL CLEARED BECAUSE THE USER DROPPED CARRIER (DCD).
CLR ERR 238 THE TRANSPORT-LEVEL OF X.25 ISSUED A CALL CLEAR BECAUSE
IT RECEIVED AN ILLEGAL DATA PACKET.
CLR ERR 239 THE LOCAL PAD INITIATED A CALL CLEAR FOR ONE OF THE
FOLLOWING REASONS:
- THE REMOTE END HAS DROPPED THE DCD SIGNAL.
- THE LOCAL PAD HAS TOO MANY BUFFERS WAITING TO BE
TRANSMITTED.
ERR 240 THE LOCAL PAD HAS TERMINATED THE CALL REQUEST BECAUSE
THERE WAS NO RESPONSE FROM THE REMOTE PAD WITHIN THE
SPECIFIED TIME PERIOD (T2 TIMER).
ERR 241 THERE ARE NO LOGICAL CHANNELS AVAILABLE TO ISSUE A CALL
REQUEST.
ERR 242 THE CALL REQUEST CANNOT BE SENT BECAUSE THE PACKET-LEVEL
RESTART PROCEDURE HAS NOT BEEN COMPLETED ON THE
ASSOCIATED X.25 LINK.
ERR 250 THE CALL REQUEST CANNOT BE COMPLETED BECAUSE THE ADDRESS
OF THE REMOTE PAD HAS NOT BEEN DEFINED IN THE LOCAL PAD.
ERR 251 THE REMOTE PAD DID NOT RESPOND TO A CALL REQUEST FOR A
SHAREABLE LOGICAL CHANNEL.
ERR 252 INVALID DATA RECEIVED FOR A SHAREABLE LOGICAL CHANNEL.
THERE IS A MISMATCH ON THE DATE LENGTH.
ERR 253 ONE OF THE FOLLOWING INVALID OPERATIONS WAS ATTEMPTED:
- ATTEMPT TO DISCONNECT A PORT THAT WAS NOT CONNECTED.
- ATTEMPT TO CONNECT A PORT THAT IS ALREADY CONNECTED.
- ATTEMPT TO CONNECT A PORT THAT IS ALREADY ASSIGNED
AS A PVC.
ERR 254 THE LOCAL PAD IS BEING REMOTELY CONFIGURED. CALL AND
CLEAR REQUESTS ARE TEMPORARILY NOT ALLOWED FROM THIS
PORT.
DEC. HEX. DESCRIPTION OF THE C.C.I.T.T. DIAGNOSTIC CODES.
==== ==== =========================================================
000 00 NO ADDITIONAL INFORMATION.
001 01 INVALID PACKET SEQUENCE NUMBER SENT.
002 02 INVALID PACKET SEQUENCE NUMBER RECEIVED.
016 10 PACKET TYPE INVALID. (GENERAL DESCRIPTION)
017 11 PACKET TYPE INVALID FOR STATE R1
018 12 PACKET TYPE INVALID FOR STATE R2 - DTE RESTART REQUEST
019 13 PACKET TYPE INVALID FOR STATE R3 - DCE RESTART INDICATION
020 14 PACKET TYPE INVALID FOR STATE P1 - DTE READY
021 15 PACKET TYPE INVALID FOR STATE P2 - DTE WAITING
022 16 PACKET TYPE INVALID FOR STATE P3 - DTE INCOMING CALL
023 17 PACKET TYPE INVALID FOR STATE P4 - DATA TRANSFER
024 18 PACKET TYPE INVALID FOR STATE P5
025 19 PACKET TYPE INVALID FOR STATE P6 - DTE CLEAR REQUEST
026 1A PACKET TYPE INVALID FOR STATE P7 - CLEAR INDICATION (DCE)
027 1B PACKET TYPE INVALID FOR STATE D1 - FLOW CONTROL READY
028 1C PACKET TYPE INVALID FOR STATE D2 - RESET REQUEST
029 1D PACKET TYPE INVALID FOR STATE D3 - RESET INDICATION
032 20 PACKET NOT ALLOWED. (GENERAL DESCRIPTION)
033 21 UNIDENTIFIABLE PACKET.
034 22 CALL ON ONE-WAY LOGICAL CHANNEL.
035 23 INVALID PACKET TYPE ON A PERMANENT VIRTUAL CIRCUIT.
036 24 PACKET ON UNASSIGNED LOGICAL CHANNEL.
037 25 REJECT NOT SUBSCRIBED TO.
038 26 PACKET TOO SHORT.
039 27 PACKET TOO LONG.
040 28 INVALID GENERAL FORMAT IDENTIFIER.
041 29 RESTART OR REGISTRATION PACKET WITH NON-ZERO IN BITS 1-4
OF THE FIRST OCTET OR IN BITS 1-8 OF THE SECOND OCTET.
042 2A PACKET TYPE NOT COMPATIBLE WITH FACILITY.
043 2B UNAUTHORIZED INTERRUPT CONFIRMATION.
044 2C UNAUTHORIZED INTERRUPT.
045 2D UNAUTHORIZED REJECT.
048 30 TIMER EXPIRED. (GENERAL DESCRIPTION)
049 31 TIMER EXPIRED FOR INCOMING CALL.
050 32 TIMER EXPIRED FOR CLEAR INDICATION.
051 33 TIMER EXPIRED FOR RESET INDICATION.
052 34 TIMER EXPIRED FOR RESTART INDICATION.
064 40 CALL SET-UP, CALL CLEARING (GENERAL DESCRIPTION)
OR REGISTRATION PROBLEM.
065 41 FACILITY/REGISTRATION CODE NOT ALLOWED.
066 42 FACILITY PARAMETER NOT ALLOWED.
067 43 INVALID CALLED ADDRESS.
068 44 INVALID CALLING ADDRESS.
069 45 INVALID FACILITY/REGISTRATION LENGTH.
070 46 INCOMING CALLS BARRED.
071 47 NO LOGICAL CHANNEL AVAILABLE.
072 48 CALL COLLISION.
073 49 DUPLICATE FACILITY REQUESTED.
074 4A NON-ZERO ADDRESS LENGTH.
075 4B NON-ZERO FACILITY LENGTH.
076 4C FACILITY NOT PROVIDED WHEN EXPECTED.
077 4D INVALID CCITT SPECIFIED DTE FACILITY.
080 50 MISCELLANEOUS. (GENERAL DESCRIPTION)
081 51 IMPROPER CAUSE CODE FROM DTE.
082 52 NOT ALIGNED OCTET.
083 53 INCONSISTENT 'Q' BIT SETTING.
112 70 INTERNATIONAL PROBLEM. (GENERAL DESCRIPTION)
113 71 REMOTE NETWORK PROBLEM.
114 72 INTERNATIONAL PROTOCOL PROBLEM.
115 73 INTERNATIONAL LINK OUT OF ORDER.
116 74 INTERNATIONAL LINK BUSY.
117 75 TRANSIT NETWORK FACILITY PROBLEM.
118 76 REMOTE NETWORK FACILITY PROBLEM.
119 77 INTERNATIONAL ROUTING PROBLEM.
120 78 TEMPORARY ROUTING PROBLEM.
121 79 UNKNOWN CALLED DNIC.
122 7A MAINTENANCE ACTION.
DEC. HEX. DESCRIPTION OF THE PAD/SWITCH DIAGNOSTIC CODES.
==== ==== =========================================================
160 A0 NON-ZERO RESET CAUSE CODE FROM DTE.
161 A1 DATA PACKET TOO LONG.
162 A2 INTERRUPT PACKET TOO LONG.
163 A3 INTERRUPT PACKET TOO SHORT (NO USER DATA).
164 A4 INTERRUPT CONFIRMATION TOO LONG.
165 A5 RECEIVER READY TOO LONG.
166 A6 RECEIVER NOT READY TOO LONG.
167 A7 RESET TOO LONG.
168 A8 RESET CONFIRMATION TOO LONG.
169 A9 INVALID 'Q' BIT IN PACKET.
170 AA PACKET WINDOW RANGE EXCEEDED.
171 AB UNABLE TO TRANSMIT PACKET.
172 AC 'Q' BIT SET IN NON-DATA PACKET.
173 AD RECEIVED P(R) EXCEEDED WINDOW SIZE.
174 AE NETWORK INTERNAL ERROR.
175 AF RESET PACKET TOO SHORT (NO CAUSE CODE FIELD).
176 B0 REJECT PACKET TOO LONG.
177 B1 INVALID PACKET I.D.
182 B6 PACKET FORMAT INVALID.
183 B7 FACILITY OCTET COUNT BALANCE OF PACKET.
184 B8 INVALID PACKET DETECTED.
185 B9 FACILITY FIELD OCTET COUNT 63.
186 BA OUTGOING CALLS BARRED.
187 BB INCOMING CALLS BARRED.
189 BD CALLED ADDRESS TOO LONG.
190 BE CALLED ADDRESS TOO SHORT.
191 BF CALLING ADDRESS TOO LONG.
192 C0 CALLING ADDRESS TOO SHORT.
193 C1 ERROR CALLED ADDRESS.
194 C2 ERROR CALLING ADDRESS.
195 C3 USER DATA FIELD TOO LARGE.
198 C6 FACILITY NEGOTIATION INVALID.
200 C8 SVC CLEARED - LOCAL ERROR - OTHER SIDE OF TP.
202 CA NO LCB AVAILABLE FOR INCOMING CALL REQUEST.
203 CB CALL PACKET LOST AFTER CALL COLLISION.
204 CC GFI/LCN OF INCOMING CALL DOES NOT MATCH CONFIGURATION.
210 D2 CALL CLEARED BECAUSE NO ROUTING POSSIBLE (TY:E).
211 D3 CALL CLEARED BECAUSE NO ROUTING POSSIBLE (TY:A).
212 D4 CALL CLEARED BECAUSE OF CONGESTION.
213 D5 CALL CLEARED BY CALL DISCONNECT SCL COMMAND.
DEC. HEX. DESCRIPTION OF THE C.C.I.T.T. CAUSE CODES.
==== ==== =========================================================
000 00 DTE ORIGINATED
001 01 NUMBER BUSY
003 03 INVALID FACILITY REQUEST
005 05 NETWORK CONGESTION
009 09 OUT OF ORDER
011 0B ACCESS BARRED
013 0D NOT OBTAINABLE
017 11 REMOTE PROCEDURE ERROR
019 13 LOCAL PROCEDURE ERROR
021 15 RPOA OUT OF ORDER
025 19 REVERSE CHARGING ACCEPTANCE NOT SUBSCRIBED
033 21 INCOMPATIBLE DESTINATION
041 29 FAST SELECT ACCEPTANCE NOT SUBSCRIBED
************************* END OF ERROR CODES **************************
Well, I hope that got you off to a good start. You should now understand
how to hack services and you should understand the various error codes....
Hackers will rule the world 4 ever!!
Seeya round, Soft Beard, the Pirate, Ahoy There!!
Imported to the U.S. by P-80 Systems 304-744-2253
TUCoPS is optimized to look best in Firefox® on a widescreen monitor (1440x900 or better).
Site design & layout copyright © 1986-2024 AOH
