|
DATAPAC OUT-DIAL PORT ADDRESSES (E.G. PC TO PC) Service - DATAPAC 3101 (ASYNC/ITI) OUT-DIAL PROCEDURES (E.G. PC TO PC) DATAPAC 3101 OUTDIAL PROCEDURES =============================== 1. SERVICE CHARACTERISTICS ----------------------- AVAILABILITY - EIGHTEEN MAJOR CENTRES (DPSA'S) ARE BEING SERVED BY OUTDIAL. THEY ARE: VANCOUVER, CALGARY, EDMONTON, REGINA, SASKATOON, WINNIPEG, TORONTO, CLARKSON, LONDON, WINDSOR, KITCHENER, HAMILTON, OTTAWA, MONTREAL, QUEBEC, HALIFAX, SAINT JOHN (N.B.) AND ST. JOHN'S (NFLD). SPEED - OUTDIAL IS AVAILABLE AT 300 OR 1200 BPS. RESTRICTIONS - OUTIAL SERVICE WILL ONLY ACCEPT SENT PAID CALLS. THE ORIGINATING END MUST USE A DEDICATED ACCESS OR USE A NETWORK USER IDENTIFIER (NUI). - CALLING AT THE TERMINATING END IS RESTRICTED TO THE LOCAL CALLING AREA FOR THE DPSA REACHED. CONFIGURATION- THE OUTDIAL PORT USES PROFILE 6, EXCEPT THAT THE USER OF THE OUTDIAL PORT IS ALLOWED TO ESCAPE TO COMMAND MODE BY USING "CONTROL P". - THE DESTINATION TERMINAL MUST BE SET AT EVEN PARITY IN ORDER TO RECEIVE THE OUTDIAL CALL. - ONCE CONNECTED, DATAPAC 3000 USERS CAN SET AND READ THE REMOTE ITI PARAMETERS BY SENDING LEVEL 1 PACKETS (X.29). 2. OUTDIAL PROCEDURES ------------------ 1) ESTABLISH A CALL TO DATAPAC VIA A DEDICATED OR DIAL-IN ACCESS. NOTE: IF USING A DIAL-IN ACCESS, A NETWORK USER IDENTIFIER (NUI) MUST BE ACTIVATED BEFORE ESTABLISHING THE CALL. 2) ENTER THE ADDRESS OF THE OUTDIAL PORT. 3) DATAPAC WILL RESPOND WITH: DATAPAC: CALL CONNECTED ENTER DESTINATION TELEPHONE NUMBER/ENTRER LE NUMERO DE TELEPHONE DU DESTINAIRE 4) ENTER THE 7-DIGIT TELEPHONE NUMBER (LOCAL) OF THE DESTINATION TERMINAL. 5) DATAPAC WILL RESPOND WITH: DIALING/COMPOSITION DU NUMERO (XXX-XXXX) PRINTING THE DESTINATION TELEPHONE NUMBER AS IT IS DIALED. 6) DATAPAC WILL THEN INDICATE: RINGING/SONNERIE AS THE MODEM DETECTS RINGBACK TONE. 7) WHEN THE DESTINATION MODEM ANSWERS THE CALL, DATAPAC WILL SEND THE FOLLOWING MESSAGE TO THE ORIGINATING END: CALL CONNECTED/COMMUNICATION ETABLIE 8) THEN PROCEED WITH YOUR CALL. 9) TO CLEAR A CALL UPON COMPLETION, ENTER THE CLEAR COMMAND: (CONTROL P) CLEAR (CR) DATAPAC WILL RESPOND WITH: DATAPAC: CALL CLEARED - REMOTE DIRECTIVE DATAPAC: TERMINAL ADDRESS NOTE: IF YOU HAVE USED A NUI TO PLACE THE CALL, TURN THE NUI OFF BEFORE LEAVING THE NETWORK WITH THE COMMAND: NUI OFF (CR) DATAPAC WILL RESPOND WITH: DATAPAC: NETWORK USER IDENTIFIER NOT ACTIVE DATAPAC OUT-DIAL PORT ADDRESSES (E.G. PC TO PC) Service - DATAPAC 3101 (ASYNC/ITI) OUT-DIAL PORT ADDRESSES OUTDIAL PORT ADDRESSES ---------------------- OUTDIAL PORT CITY (PROVINCE) SPEED ADDRESS --------------- ----- ------- Calgary (ALTA) 300 63300900 1200 63300901 Clarkson (ONT) 300 91900900 1200 91900901 Edmonton (ALTA) 300 58700900 1200 58700901 Halifax (NS) 300 76101900 1200 76101901 Hamilton (ONT) 300 38500900 1200 38500901 Kitchener (ONT) 300 33400900 1200 33400901 London (ONT) 300 35600900 1200 35600901 Montreal (QUE) 300 82700902 1200 82700903 Ottawa (ONT) 300 85700901 1200 85700902 Quebec City (QUE) 300 48400900 1200 48400901 Regina (SASK) 300 72100900 1200 72100901 St-John's (NB) 300 74600900 1200 74600901 Saskatoon (SASK) 300 71100900 1200 71100901 St. John (NFLD) 300 78100900 1200 78100901 Toronto (ONT) 300 91600901 1200 91600902 Vancouver (BC) 300 67100900 1200 67100901 Windsor (ONT) 300 29500900 1200 29500901 Winnipeg (MAN) 300 69200902 1200 69200901 .