MEI HT5000

NOTES:  This is a dual NAM handheld unit.
        The ESN prefix is 167 decimal, A7 hex.
        Monsor Electronics: 416-475-8444

PROGRAMMING:

1.  With the power OFF plug in the programing adaptor, if this is not
    available short pins 1 and 6 (end pins on the top row).

2.  Power the phone up by pressing and holding the PWR button, the phone
    will go straight into programing mode.

3.  RCL enters data and increments the step number.

4.  MUT increments the step number without storing data.

5.  SND decrements the step number without storing data.

6.  At any time  END completes programing and exits.  Wait at least 3
    seconds before turning the power off.

PROGRAMING DATA:

STEP#    #OF DIGITS/RANGE    DESCRIPTION

01       0 OR 1              ALLOW USER A/B SWITCHING
02       0 OR 1              LOW BATTERY ALARM
03       0 OR 1              0= 10 MEM LOCATIONS, 1=100 MEM LOCATIONS
04       0 OR 1              ROAM ENABLE
05       0 OR 1              DTMF DIALLING (END TO END)
06       0 OR 1              HORN ALERT
07       0 OR 1              0= NUMERIC MEM, 1= ALPHA MEM
08       0 OR 1              MUSIC ON MUTE
09       0 OR 1              USER CUMULATIVE TIMER RESET
10       0 OR 1              AUTO METER SWITCH FROM BATT LEVEL TO RSSI
11       NOT USED
12       0 OR 1              LOCK CODE REQUIRED TO RESET AIR TIMER
13       0 OR 1              LOCK CODE REQUIRED TO DISPLAY MIN
14       NOT USED
16       NOT USED
17       0, 1 OR 2           LOCK MODE 0=TOTAL, 1=OUTGOING ONLY, 3=PARTIAL
18       1 TO 10 DIGITS      LOCK CODE
19       0 TO 255 SECONDS    BACK LIGHT TIMER
20       10 DIGITS           MIN (AREA CODE & TEL NUMBER)
21       00000 - 32767       SYSTEM ID
22       333 OR 334          INITIAL PAGING CHANNEL
23       2 DIGITS            STATION CLASS MARK
24       0 OR 1              PREFERRED SYSTEM 0=B, 1=A
25       0 OR 1              MIN MARK
26       2 DIGITS            ACCESS OVERLOAD CLASS
27       2 DIGITS            GROUP ID (10 IN USA)
28       0 OR 1              LOCAL USE MARK

NAM 2 DATA:

29       10 DIGITS           MIN (AREA CODE & TEL#)
30       00000 - 32767       SYSTEM ID
31       333 OR 334          INITIAL PAGING CHANNEL
32       2 DIGITS            STATION CLASS MARK
33       0 OR 1              PREFERRED SYSTEM 0=B, 1=A

LOCK: F 7.  UNLOCK: Enter three digit code.

SYSTEM SELECT: (Only if step 1 above is set to "1") Press F # 6 to display, 6
to scroll CLR to exit.