MOBIRA TPA-4/400, THA-5/500

NOTES:  All 500 series units are dual NAM.
        Some 400 series units are single NAM.
        The ESN prefix is 156 decimal, 9C hex.
        Mobira: 813-536-5553

PROGRAMING:

1.  Turn on power.

2.  Go to the special function menu by entering MENU, FCN, NEXT, OK, FCN,
    NEXT, OK.  (A * should appear in the display).

3.  Enter * 2 1 0 5 7 # S S S S S OK (where SSSSS is the security code).
    The factory default security code is 12345.

4.  The NEXT key is used to scroll through the parameter NAMES.

5.  To display and/or change a parameter VALUE press OK.
    Parameter values are either NUMERIC, or single option TEXT & 0/1.
    For NUMERIC parameters enter the new value and press OK to store.
    For TEXT & 0/1 parameters press NEXT to toggle and OK to store.

6.  Press FCN CLR and turn off power to exit programing mode.


PROGRAMING DATA:

STEP#    #OF DIGITS/RANGE    DISPLAY             DESCRIPTION

01       PRIMARY/OPTIONAL    SELECT NAM USED     TOGGLE NAM 1 OR 2
02       DISABLED/ENABLED    OPTIONAL NAM        TOGGLE NAM 2 ACCESS
03       00000 - 32767       HOME SYS            SYSTEM ID
04       0 OR 1              ACCESS M            TOGGLE MIN MARK
05       0 OR 1              LOCL OPT            TOGGLE LOCAL USE MARK
06       10 DIGITS           OWN NUM             MIN (AREA CODE & TEL#)
07       2 DIGITS            ST CLASS            STATION CLASS (ALWAYS 08)
08       0333 OR 0334        PAGING CH           INITIAL PAGING CHANNEL
09       2 DIGITS            OVERLOAD CLASS      ACCESS OVERLOAD CLASS
10       A OR B              PREF SYS            TOGGLE PREFERRED SYSTEM
11       2 DIGITS            GROUP ID            GROUP ID (10 IN USA)
12       5 DIGITS            SECURITY            SECURITY CODE
13       CAN'T BE CHANGED    1 DATE              CONTROL DATE
14       MM/DD/YY            2 DATE              INSTALLATION DATE
15       MM/DD/YY            3 DATE              OPTIONAL CONTROL DATE
                                                 (NOT ALL SOFTWARE VERSIONS)

NOTES:  Step 01 and 02 will not appear in single NAM units, step 02 must
        be enabled to program NAM 2.

        The lock code must be changed out of programing mode, enter:
        MENU, FCN, NEXT, NEXT, NEXT... (Repeat until display shows "UNLOCK
        CODE") OK, SSSSSS, LLLL, OK (where SSSSS is the security code and
        LLLL is the new lock code).

LOCK: F 0.  UNLOCK: Enter four digit code.

SYSTEM SELECT: FCN 1 then NEXT to scroll, OK to store/exit.