NEC  M4700 (TR5E800-11H) QUAD NAM

NOTES:  This is quad NAM unit.
        The ESN prefix is 135 decimal, 87 hex.
        NEC: 1-800-421-2141

1.  This phone officially requires an NEC programing adaptor part
    number 41-2012, if you have one attach it between the data cable and the
    transceiver and power up the phone.

    If you do not have a programing adaptor one can be made from a 15 pin
    D plug and a 15 pin D socket.  Wire it straight through and jumper pins
    2 and 11.  Connect this between the transceiver and data cable and power
    up the phone.

    (New units may display FAULT 3 when first turned on, this is normal.
    With your programing adaptor installed initialize the phone by entering
    RCL # 0 1, RCL # 5 2, RCL # 0 2.  The phone should re-cycle and wake up
    with no FAULT code.)

2.  Having powered up the phone using one of the above methods press
    RCL # 0 1 to enter test mode.

5.  Press RCL # 7 1 to enter programing mode.

4.  (Optional) Press RCL # 7 6 N where N=0 (NAM 1), N=1 (NAM 2), N=2 (NAM 3)
    or N=3 (NAM 4).

6.  The # key stores and increments each step.

7.  Press CLR briefly to correct an entry.

8.  At any time press and hold CLR to exit programing mode then press RCL
    # 0 2 to exit test mode.

PROGRAMING DATA

STEP#    #OF DIGITS/RANGE    DESCRIPTION

01       10 DIGITS           MIN (AREA CODE & TEL#)
02       4 DIGITS            LOCK CODE
03       00000 - 32767       SYSTEM ID
04       2 DIGITS            GROUP ID (10 IN USA)
05       0333 OR 0334        INITIAL PAGING CHANNEL
06       0 OR 1              PREFERRED SYSTEM
07       2 DIGITS            ACCESS OVERLOAD CLASS
08       0 OR 1              MIN MARK
09       0 OR 1              LOCAL USE MARK
10       0 OR 1              RADIO MUTE
11       0 OR 1              HORN ALERT  (ONLY AVAILABLE IF STEP 10 IS
                             SET TO 0)

LOCK: F * four digits = Partial lock, F # four digits = Full lock.  Use same
sequence to unlock.

SYSTEM SELECT: F 5 then 5 to scroll.