|
NOVATEL 8325 NOTES: This is a quad NAM unit. The ESN prefix is 142 decimal & 8E hex Novatel: 1-800-527-2885 NAM PROGRAMING: 1. Turn power on. 2. Press FCN 1 or FCN LOCK. 3. Use the volume key to scroll to FULL LOCK. 4. Press SND. 5. Press 2 5 5 # 5 1 0 * or 2 6 6 # 5 1 0 * to enter programing mode. 6. The SND key is used to store entered data and to toggle options. 7. The volume up key increments the steps. 8. Note that data for steps 16 through 19, system id lockouts, must be preceded with a # sign. IE: #00031 SEND. 9. This unit is equipped with a "Tamper Protection" option, if the phone displays "PASSWORD" after step 04 below then a six digit code must be entered to change data. It is strongly suggested that this option NOT be used. 10. The END key completes and exits programing mode. NAM DATA: STEP# #OF DIGITS/RANGE DISPLAY DESCRIPTION 01 CAN NOT BE CHANGED CNF REV SOFTWARE REVISION 02 CAN NOT BE CHANGED ESN HEX ESN 03 0 TO 4 NAM x SEL SELECT NAM 1-4 (ENTERING 0 AT THIS STAGE WILL STEP DIRECTLY TO ENTRY 26 BELOW) 04 ENABLE/DISABLE NAM x ENABLE TOGGLE NAM ENABLED/DISABLED (If "PASSWORD" appears see note 10 above) 05 10 DIGITS MIN MIN (AREA CODE & TEL NUMBER) 06 00000 - 32767 SIDH SYSTEM ID 07 TOGGLE TP OFF OR END (NOT ALL UNITS) You may press END at this stage to return to NAM select, step 03, then press "0" to go directly to step 26 below. Steps 09 through 25 are set automatically. Press volume down if you wish to review or change steps 09 through 25. It is suggested that you do not press SND which will display the following: 08 6 DIGITS TP CODE ENTER 6 DIGIT PASSWORD (PRESS SND TO STORE) AGAIN RE ENTER PASSWORD TO CONFIRM 09 SET/CLR OPTION EX TOGGLE EXTENDED ADDRESS (SET=1, CLR=0) 10 0333 ONLY IDCCA SYS A INITIAL PAGING CHANNEL 11 0334 ONLY IDCCB SYS B INITIAL PAGING CHANNEL 12 2 DIGITS ACCOLC ACCESS OVERLOAD CLASS 13 2 DIGITS GIM GROUP ID 14 1 ONLY REG TBL DATA SCAN TABLE SIZE 15 SET/CLR OPTION LU TOGGLE LOCAL USE (SET=1, CLR=0) 16 # 00000 - 32767 INVLD ID 1 SYSTEM ID LOCKOUT 17 # 00000 - 32767 INVLD ID 2 SYSTEM ID LOCKOUT 18 # 00000 - 32767 INVLD ID 3 SYSTEM ID LOCKOUT 19 # 00000 - 32767 INVLD ID 4 SYSTEM ID LOCKOUT 20 SET/CLR OPTION FD TOGGLE END TO END (DTMF) DIALING (SET=ON, CLR=OFF) 21 SET/CLR OPTION MFD TOGGLE EXTENDED DTMF (SET=ON, CLR=OFF) 22 SET/CLR OPTION 32D TOGGLE 32 DIGIT DIALING (SET=ON, CLR=OFF) 23 SET/CLR OPTION PS TOGGLE PREFERRED SYSTEM (SET=A, CLR=B) 24 SET/CLR OPTION IRI TOGGLE ROAM INHIBIT (SET=NO ROAM, CLR=ALLOW ROAM) 25 SET/CLR OPTION SSD TOGGLE SIGNAL STRENGTH DISP (SET=ON, CLR=OFF) 26 SND/VOL INIT REP PRESS SND TO INITIALIZE MEMORY LOCATIONS 27 4 DIGITS LOCKCODE LOCK CODE (Kn00 VERSION HAS LOCK 1 & LOCK 2) 28 SET/CLR OPTION QRC TOGGLE QUICK RECALL (SET=ON, CLR=OFF) 29 SET/CLR OPTION QST TOGGLE QUICK STORE (SET=ON, CLR=OFF) 30 SET /CLR OPTION WUT TOGGLE WAKE UP TONE (SET-ON, CLR=OFF) 31 SET/CLR OPTION MLH TOGGLE MOBILE-LAND HANDOFF (SHOULD BE CLR) 32 SET/CLR OPTION LMH TOGGLE LAND-MOBILE HANDOFF (SHOULD BE CLR) 33 SET/CLR OPTION CRU TOGGLE CALL ROUND UP (SHOULD BE CLR) 34 SET/CLR OPTION EE TOGGLE END TO END (DTMF) DIALING (SET=ON, CLR=OFF) 35 SET/CLR OPTION NLM EUROPE ONLY (SHOULD BE CLR) 36 SET/CLR OPTION HAL TOGGLE HORN ALERT (NOT ALL PHONES) (SET=ON, CLR=OFF) 37 SET/CLR OPTION ONL TOGGLE ONLINE DIAGNOSTICS (SET=ON, CLR=OFF) LOCK: F 1 (or LOCK key). UNLOCK: Enter four digit code.