UNIDEN 5000 and 6000 GTS Portable


                NAM Type:  EEPROM
            Manufacturer:  UNIDEN
              Programmer:  Program or Service Handset with CP 505 Adaptor
          ESN Prefix DEC:  172
                     HEX:  AC
 ESN, S/N Match Required:  Yes
    Stamped Model Number:  5000 or 6000 GTS
      Number of Channels:  832

    Programming Sequence:  Power Off
                           Remove Battery and install CP505 or CP505A adaptor
                           Connect CP505(A) to power supply or to CP
                            504 battery eliminator per adaptor instructions
                           Connect Program Handset to CP 505(A) adaptor
  White Handset (CP-010):  Turn Power Switch On while holding *
                            and # continue holding * and # for two seconds
    Blue Handset(CP-210):  Turn Power Switch On
                           Press SELECT + 2 + SEND
           Both Handsets:  Enter step number, then data for individual
                            parameter
                           Press STO to enter data for each step
                           Increment by pressing next step number
 To review parameters press:  RCL + Step number + STO (to exit)
                           To select Alternate NAM, Press 1 + STO + 90 (NAM 1)
                            or 2 + STO + 90 (NAM 2)
                           Press SEND to write NAM information
                           PASS will appear in display if data is valid

 Step                 # of Digits
 0             System ID:  5    XXXXX + STO
 1             Local Use:  1    (0 or 1) + STO
 2               MIN Opt:  1    (0 or 1) + STO
 3         Mobile Number:  10   XXX-XXX-XXXX + STO
 4  Initial Page Channel:  3    (333 or 334) + STO
 5       Access Overload:  2    XX + STO
 6      Preferred System:  1    [0 (B) or 1 (A)] + STO
 7              Group ID:  2    XX + STO
 8         Lock code (1):  4    XXXX + STO
 9  Options F5 DTMF
                Duration:  1    0 - Continuous
                                1 - 100 ms

Press STO to program phone

         New Unlock Code:  RCL + 70 + Current 4 digit Unlock code
                            + new 4 digit Unlock code

           System Select:  X + STO + 8 + 8
                            X=1  A only
                            X=2  B Only
                            X=3  Home
                            X=4  Standard AB or BA
                            X=5  Inverted BA or AB